2. Bimba
  3. PneuMoment® Actuators Preventative

Bimba PneuMoment® Actuators Preventative Operating instructions

  • I have analyzed the provided Product Instructions for the Bimba PneuMoment Actuator and I'm ready to assist you with any questions you may have. The document specifies lubrication requirements, including the use of HT-99 oil and instructions for additional lubrication, as well as recommendations for factory repair.
  • What type of oil is used for factory lubrication?
    How often should I lubricate the actuator?
    Is further lubrication between the load beam and guide beam needed?
1
PREVENTATIVE MAINTENANCE LUBRICATION REQUIREMENTS
PneuMoment actuators are factory lubricated. Internally, the air cylinder is lubri-cated with our proprietary HT-99
petroleum based oil for extensive maintenance-free operation. A small amount of lightweight oil is used to assist
the assembly of the load beam into the guide beam.
Actuator life can be greatly extended by providing additional lubricant with an air line mist lubricator or direct
introduction of non-detergent petroleum based oil into the internal cylinder via the ports every 500 hours of
operation. No further lubrica-tion between the load beam and guide beam is necessary.
Factory repair is recommended.
Please contact Bimba at 1-800-44-BIMBA for instructions on returning a unit for factory repair.
Product Instructions
PneuMoment Actuator
Form: BMS-1115
Bimba Manufacturing Company
Monee, IL 60449-0068
Tel: 708.534.8544
Fax: 708 235 2014
Email: [email protected]
Website: www.bimba.com
/