Warrior Products 592, 593 Installation guide

Hello! I've reviewed the installation instructions for the Warrior Products Rear Bumper WAR 592/593 designed for the Jeep Wrangler JK. This document details the step-by-step process of removing the old bumper and installing the new one, including adjusting for hitch wiring and proper alignment. I'm ready to answer any questions you may have about this installation process.
What size bolts are used to remove the factory rear bumper?

What should be done with the factory bumper braces?

What modification might be needed on vehicles with a factory hitch?

Protecting Your Adventure Lifestyle

========================================================================================

QUALITY • INTEGRITY • INNOVATION • SERVICE

Warrior Products, Inc.

16850 SW Upper Boones Ferry Rd

Ste. A

Durham, OR 97224

Phone (888) 220-6861

Fax (503) 692-0364

JEEP WRANGLER JK REAR BUMPER

INSTALLATION INSTRUCTIONS

WAR 592/593

Installation:

1. Remove factory rear bumper - This is done by removing two 16mm bolts on either side of the

frame rail. The factory rear bumper will also have two braces bolted to the underside of the rear

cross member. Remove and discard these braces and hardware as they are no longer needed.

2. On factory hitch equipped vehicles, the bumper may need to be slightly modified to clear the

wiring plug bracket. Alternatively, the wiring plug bracket may be removed altogether.

3. Set bumper into place – Bolt into location with factory hardware. Ensure the bumper is aligned

and level, then tighten bolts.

4. Installation Complete - Your new bumper is now installed.

If you need further assistance installing your product, please contact us by email at

[email protected] or call us at (888) 220-6861.

THANK YOU FOR PURCHASING WARRIOR PRODUCTS