2. BLOTZ
  3. B28-SF-233

BLOTZ B28-SF-233 Assembly Instructions

  • Hello! I've reviewed the instructions for assembling the BLOTZ Doors B28-SF-233 model. These instructions cover the materials needed, such as PVA glue and a modeling knife, as well as the steps for constructing the doors, including gluing the frames and painting the completed model. I'm ready to assist with any questions you might have about them.
  • What type of glue is recommended for assembly?
    What tool is needed to remove the parts from the sprue?
    What can be used to hold the pieces in place while the glue dries?
28mm Doors #2
B28-SF-233
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Each door is made from the components shown above.
Stick the frame to the door.
The completed doors
The doors once painted.
/