2. BLOTZ
  3. B20-ACC-002

BLOTZ B20-ACC-002, B20_ACC_002 Assembly Instructions

  • Hello, I've reviewed the instructions for the BLOTZ Subway B20-ACC-002 model. The document provides step-by-step instructions for assembling the 20mm scale model using glue, sandpaper and modeling knife, ensuring safe construction. I'm ready to answer any questions you have about its construction or the materials needed.
  • What kind of glue is required?
    What can be used to clean joints?
    What safety precaution should be taken with a sharp modeling knife?
20mm Subways
B20-ACC-002
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Take all the pieces for a subway entrance from
the sprue (as shown above).
Apply some glue to the short end and place it into the
slots on the base (as shown) – DO NOT push it
complete home at this point.
Using the lugs on the sides of the piece you have
already positioned, slide the two long side pieces
into place. You can now push the end piece fully
home. Ensure the opposite ends of the side
pieces are still proud (see above).
Place the subway sign piece into position using the
lugs on its edges to align it with the side pieces, then
push it home into the holes on the base.
The view from the front once the sign is in
position.
/