2. BLOTZ
  3. B10-ME-204

BLOTZ B10-ME-204 Assembly Instructions

  • Hello, I've reviewed the instructions for the BLOTZ City Wall B10-ME-204. The document details the steps for assembling the 10mm scale model, including attaching the gate and the various wall sections. I'm ready to answer your questions about the assembly process or other aspects related to this product.
  • What kind of glue is needed?
    What tools are needed?
    How should I hold the pieces together while the glue dries?
10mm Ancient City Wall – Short Wall with Gate
B10-ME-204
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Take the pieces shown above from the sprue.
Glue them together as shown.
Take these pieces.
Glue them together to form an archway.
Using these pieces…
Glue them together to form this.
Take the base and gates.
Attach the model to the base, but just before pushing
it into place, slot the gates into their holes.
Add the walkway.
The front lower wall and end-fillers.
Glue the end fillers into place.
Then add the front lower wall.
The upper wall and strip.
Glue them into place.
/