Danfoss Pressing tool Installation guide

Type
Installation guide
This pressing tool for sanitary press fitting systems
ist manufactored on the newest technical niveau
and and considering of all relevant security laws.
The tool is only allowed to use when it works
propper and is only for use with the in this
manual described purpose.
Please take care, that all relevant laws for working
secure have to be followed by the user.
It is not allowed to change anything at this tool,
otherwise Danfoss is not responsible for any
following damages.
Introduction
Instruction
Pressing tool
Danfoss HES VI.CT.D1.02 © Danfoss 11/2008 1
To be used for
Function
This tool is to be used to press sanitary press
fittings (not for copper and steel systems).
• Putinthettingasinstructedbythesystem
supplier (see technical documentation).
• Openthetoolhead(1)byopeningthelever(2)
and bring the fitting into correct position.
• Incaseofhavingtolessspacetoputinthe
fitting propper, it is possible, to open the tool
while pulling back the slider (pic. 1).
• Thetoolhastobeclosedcompletelybefore
opening it again.
Pic. 1
Tool head
Tool lever
Closure
Slider
Instruction Pressing tool
Assembling of the inserts
(dies)
Service and cleaning
hints
2 VI.CT.D1.02 © Danfoss 11/2008 Danfoss HES
• Closurehastobeturned90°(pic.2).
• Headofthetoolhastobeopenedsome
milimeter.
• Putintheinsert(die)untilstopdevice(pic.3).
• Pushbackcloserinclosingposition.
tool is only allowed to used in combination
with the valid security laws such as german
UVV and similar ( European law for machines
89/392/EWGandothers).
do not throw the tool or hit with a hammer or
other tools.
only to be used for heating and plumbing press
fittings.
protect tool from dust and other pollution like
cement.
in case of impurity, please clean the tool
immedeatly.
tool should be stocked in case and dry rooms.
tool should be checked before working with it
(cracks or similar).
all mobile parts have to be oiled regular.
please check tool every 4 weeks if it closes
completey the maximum dimension.
Pic. 2
Pic. 3
  • Page 1 1
  • Page 2 2

Danfoss Pressing tool Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages