Assembly Instructions
Caution : You must read this before you proceed.
BISTRO TABLE
CAUTION : This table is NOT a TOY.
Keep your child / children at bay in the process of assembly.
1 OF 5
No. Picture Description Qty
A
Table Top 1
B
Table Legs 3
C
Leg - Ring Support 1
No. Picture Description Qty
Flat Washers ( 8mm ) 7
Spring Washers ( 8mm ) 7
Nuts ( 8mm ) 7
G
Studs (M8*35mm) 7
Flat Washers ( 6mm ) 4
Spring Washers ( 6mm ) 4
Nuts ( 6mm ) 4
K
Bolts (M6*35mm) 4
L
Screwdriver 1
M
Spanner 1
D
H
Before Beginning Assembly:
2 OF 5
Unpack and place all parts on a clean soft surface.
Lay the Table Top(A), Top being floor facing, onto a flat soft clean
surface .
Fix the Studs(G) to the Table Top(A) with the Screwdriver(L).
Then attach the Table Legs(B) to the the Table Top(A) using
Washers,Spring Washers, and Nuts(D) with the Spanner(M).
DO NOT OVER TIGHTEN at this stage.
Step 1
Step 2
3 OF 5
Attach the Leg Ring Support Ring(C)to Table Legs(B) using Bolts(K),
Washers,Spring Washers, and Nuts（H）.
Use one Screwdriver (L) to hold the bolt, and with the other Spanner
(M), turn in the Nut(H).
DO NOT OVER TIGHTEN at this stage.
Repeat the same process for all 3 Legs.
Step 4
Turn the table rightside.
Adjust the Legs pre-installed Levellers until the table is level with the
ground.
Upon completion of full assembly, tighten and bolt up-all screws.
Your table is now ready for use.
Step 3
4 OF 5
5 OF 5
/
