M10 x 1.0
2-1/2”
1/4” Tubing adapter
8”
2-3/8”
1-3/4”
2-1/8”
9”
1/2 ”
5-1/2”
D2035
Pure Water Faucet
For use with filtration units.
Fits PVC or
copper tubing
water supplies
1. Remove the mounting nut and
base washer from the faucet.
2. Seat O-ring in base groove.
If desired a thin bead of silicone
seal can be applied to the O-ring
for added sealing power. Please
do not use Plumber’s Putty.
3. Center the faucet in the mount-
ing hole and fasten with base
INSTALLATION
INSTRUCTIONS:
washer and mounting nut. Do not over tighten.
4. Make sure the tubing end is free from burrs, or gouges and is
cut squarely.
5. For 1/4” tubing, thread the brass John Guest adapter onto the
yaw eht lla gnibut eht sserp ylmrfi dna elppin gnitnuom tecuaf
into the end of the fitting.
6. Fully open the handle on the pure water faucet and then turn
on the water supply. Allow the water to run to rinse any debris
from the system.
7. Check for leaks especially at the water supply attachments.
2429 E Olympic Blvd., Los Angeles, CA 90021
800-392-7277 • 213-627-8441 • www.westbrass.com
Fine Decorative Plumbing Since 1935
WESTBRASS
/
