2. Rugged Ridge
  3. Euro-Style Turn Signal & Side Marker Guards

Rugged Ridge Euro-Style Turn Signal & Side Marker Guards Installation guide

  • Hello! I have analyzed the installation instructions for the Quadratec Light Guard Kit for the TJ model. The document provides step-by-step guides for mounting the front turn signal and side marker lamp guards, including information on drilling and the use of spacers. I am ready to answer any questions you have about this kit.
  • How to mount the front light guards?
    How to mount the side marker lamp guards?
    Are spacers always required for installing side light guards?
(4) PC Light Guard Kit for TJ (Black)
P/N: 5670
Step (1) Remove the front turn signal mounting screws.
Place front guard over lamp and attach with longer
supplied screws. Repeat for other side.
Step (2) To mount the side marker lamps place one guard
over the lamp and mark the mounting hole location
with a scribe or pen. Use a 3/16” drill bit and drill
drill holes in the flare at the scribed spots. Use the
supplied allen head bolts and nuts to secure the
guard to the flare.
Note: Some Jeep models will require the use of the black
spacers to clear bulges in the flare in relation to the
side marker lamps. Not all of the spacers may be
needed.
/