2. BLOTZ
  3. B20_RU_002

BLOTZ B20_RU_002, B20-RU-002, B28-RU-002 Assembly Instructions

  • Hello! I have reviewed the instructions for the BLOTZ Ruined Building B28-RU-002. This document provides guidance on assembling the model using PVA glue and a modeling knife. The instructions detail the steps, from removing pieces from the sprue to assembling the roof. I'm ready to answer any questions you may have about building the model.
  • What kind of glue is required for assembly?
    What tools are needed for assembly?
    What is the first step in assembling the building?
28mm Ruined Building #2
B28-RU-002
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Ruined Building #2 (B28-RU-002)
Start by removing the upper floor and two
internal walls (shown above) from the sprue.
Glue the walls to the floor as shown.
Glue the inside front wall to the floor. Note the
etched window frames are inside the building.
Attach the small back wall, then the two end walls.
Glue thre front frame into place.
Followed by the right-hand end
And the left hand end.
Then add the frame for the back wall.
Attach the roof beams using the lugs / holes
provided in the end walls.
Finally glue the roof tiles into position.
/