3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.
*Disconnect power before installing, adding or changing any component.
*To avoid a hazard to children, account for all parts and destroy all packing materials.
*Use only with UL approved power supply.
*http://www.3m.com/3M/en_US/bonding-and-assembly-us/resources/full-story/?story-
id=b3996cbd-9954-455f-8e72-88e452ca38c0
1. Plug the connector on the power supply cord into the connector attached to the light.
2. To install the wire management clips slide the cord into the clip and turn 90° to ensure the cord will stay in place. Then determine
installation location and install by removing the paper backing and pressing in place.
INSTALLATION INSTRUCTIONS
Rana™ Task Light
Part#: 69D25X-XX
For warranty information please visit www.itc-us.com/warranty-return-policy
DOC #: 710-00034 • Rev B • 06/26/23
Page 1 of 1
PARTS/TOOLS NEEDED:
Rana Light Power Supply Wire Management Clip Power Drill
3. The switch is at the end of the lamp. Press to turn light on. To use the dimming function, press and hold the switch in. It will dim to
its lowest cycle and then start to brighten again. Release the switch when the light intensity is at the desired level.
