ITC 69D25X-XX Installation guide

Brand: ITC

Model: 69D25X-XX

Type: Installation guide

ITC 69D25X-XX is a versatile task light designed for various installation types, including wood overhead, metal overhead, and clamp mount, making it suitable for desks, workbenches, or any area that requires focused lighting. With its adjustable brightness levels, it provides optimal illumination for different tasks and environments. The light's sleek design and easy installation process make it a practical and stylish addition to any workspace.

ITC 69D25X-XX is a versatile task light designed for various installation types, including wood overhead, metal overhead, and clamp mount, making it suitable for desks, workbenches, or any area that requires focused lighting. With its adjustable brightness levels, it provides optimal illumination for different tasks and environments. The light's sleek design and easy installation process make it a practical and stylish addition to any workspace.

3030 Corporate Grove Dr.

Hudsonville, MI 49426

Phone: 616.396.1355

itc-us.com

IMPORTANT SAFETY INSTRUCTIONS. READ CAREFULLY FOR YOUR PROTECTION AND SAVE ALL INSTRUCTIONS.

*Disconnect power before installing, adding or changing any component.

*To avoid a hazard to children, account for all parts and destroy all packing materials.

*Use only with UL approved power supply.

Metal Overhead Installation:

If installing on a metal overhead, ﬁrst determine installation

location and simply attach the light to the overhead using the

magnet end.

*http://www.3m.com/3M/en_US/bonding-and-assembly-us/resources/full-story/?story-

id=b3996cbd-9954-455f-8e72-88e452ca38c0

2. Plug the connector on the power supply cord into the connec-

tor attached to the light.

1. Wood Overhead Installation:

Clean the mounting surface with a 50/50 mixture of alcohol

and water prior to installation. For more detailed instructions

please refer to the 3M website*.

The light will come with the mounting plates already attached

to the light, simply remove the tape backing and press in

place. For added security, remove light from metal mounting

plate and screw mounting plate to overhead.

3. To install the wire management clips slide the cord into the

clip and turn 90° to ensure the cord will stay in place. Then

determine installation location and install by removing the

paper backing and pressing in place.

INSTALLATION INSTRUCTIONS

Rana™ Task Light

Part#: 69D25X-XX

For warranty information please visit www.itc-us.com/warranty-return-policy

DOC #: 710-00034 • Rev A • 10/18/18

Page 1 of 1

PARTS/TOOLS NEEDED:

Rana Light Power Supply Mounting Plate w/ Screw

(Wood installation only)

Wire Management

Clip Power Drill

Clamp Mount Installation:

Turn the knob counter-clockwise (left) to loosen the clamp.

Place clamp in desired location and turn knob clockwise

(right) to tighten on to desk.

4. The switch is at the end of the lamp. Press to turn light on. To

use the dimming function, press and hold the switch in. It will

dim to its lowest cycle and then start to brighten again. Re-

lease the switch when the light intensity is at the desired level.

1

ITC 69D25X-XX Installation guide

Brand: ITC

Model: 69D25X-XX

Type: Installation guide

ITC 69D25X-XX is a versatile task light designed for various installation types, including wood overhead, metal overhead, and clamp mount, making it suitable for desks, workbenches, or any area that requires focused lighting. With its adjustable brightness levels, it provides optimal illumination for different tasks and environments. The light's sleek design and easy installation process make it a practical and stylish addition to any workspace.

Related papers

Other documents