BrandMotion FLTW-7624 Installation guide

BrandMotion
Brand
BrandMotion
Model
FLTW-7624
Type
Installation guide
INSTALLATION INSTRUCTIONS
Ford F-Series 8-inch MyTouch Cargo Camera
Plug and Play harness 2013-Current
(Kit # FLTW-7624)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
Factory T-harness
These instructions
Zip ties
Electrical tape
Heat shrink
7mm socket
Plastic panel removal tools
Safety Precautions:
● Work in well ventilated area that is clear of obstructions.
● Secure vehicle with tire chucks in both front and rear of tires.
● Turn vehicle accessories OFF and ensure ignition key is in OFF position.
● Wear safety goggles and snug fitting clothes.
● Use tools only for their intended purpose and which are in good repair.
● Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
FLTW-7624 instructions 5-11-2021 Page 1 of 3 KB
INSTALLATION INSTRUCTIONS
***NOTE: FOR THIS HARNESS TO WORK CORRECTLY, THE VEHICLE
MUST
HAVE AN EXISTING
BACKUP CAMERA. OTHERWISE, IT WILL HAVE TO BE TAKEN TO A DEALER AND UPDATED OR
THE 9002-2781 BACKUP CAMERA INTERFACE MUST BE ADDED AND INSTALLED (sold
separately). ***
This harness works with sensing technology to automatically use your secondary camera in
reverse whenever the camera is powered. The toggle switch will supply accessory power to
the secondary camera when in the ON position. When the secondary camera is powered, that
image will be displayed on the screen when the vehicle is in reverse.
FLTW-7624 instructions 5-11-2021 Page 2 of 3 KB
INSTALLATION INSTRUCTIONS
INSTALLING:
1. Remove trim around screen/display.
2. Remove the four 7mm bolts that hold display screen to dash.
3. Remove the large plug to the left of the display by lifting the handle like plug.
4. Plug the factory harness that was just unplugged from the display into the female end of the
FLTW-7624.
5. Plug the other end of the FLTW-7624 into the factory display. Lock the plug in by pushing down on the
“handle”.
6. Connect the RED wire labeled “ACC” from the FLTW-7624 to a 12V accessory source.
7. Connect the BLACK wire labeled “GND” from the FLTW-7624 to a clean Chassis Ground
8. Connect the wire labeled “CAMERA POWER” to the Aux/Cargo camera(not supplied) power wire. The
switch on this wire will allow the user to toggle the power for the cargo camera. You will still need to
connect your camera ground wire to a clean chassis ground to ensure a quality image.
9. If you have an existing OEM backup camera, leave the VIDEO 1 RCA taped to the OEM CAMERA RCA.
If you are adding an aftermarket camera, untape and connect the aftermarket camera to the VIDEO 1
RCA.
10. Mount the toggle switch in an accessible position. Position 1 enables VIDEO 1 display when in reverse;
position 2 enables VIDEO 2 display in reverse.
FLTW-7624 instructions 5-11-2021 Page 3 of 3 KB
  • Page 1 1
  • Page 2 2
  • Page 3 3

BrandMotion FLTW-7624 Installation guide

BrandMotion
Brand
BrandMotion
Model
FLTW-7624
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents