BrandMotion FLTW-7625
The BrandMotion FLTW-7625 is a third brake light cargo camera designed for 2015-Current Ford F-150 and 2017 Ford SuperDuty vehicles. It provides a clear view of the rear or front of your vehicle, depending on how you configure it.
Key features of the FLTW-7625 include:
- Easy installation: The camera simply replaces your existing cargo lamp, making it quick and easy to install.
- Waterproof design: The camera is waterproof, so you can use it in all weather conditions.
- Night vision: The camera has night vision, so you can see clearly even in low-light conditions.
- Grid lines: The camera has grid lines that can be turned on or off, making it easier to judge distances.
BrandMotion FLTW-7625
The BrandMotion FLTW-7625 is a third brake light cargo camera designed for 2015-Current Ford F-150 and 2017 Ford SuperDuty vehicles. It provides a clear view of the rear or front of your vehicle, depending on how you configure it.
Key features of the FLTW-7625 include:
- Easy installation: The camera simply replaces your existing cargo lamp, making it quick and easy to install.
- Waterproof design: The camera is waterproof, so you can use it in all weather conditions.
- Night vision: The camera has night vision, so you can see clearly even in low-light conditions.
- Grid lines: The camera has grid lines that can be turned on or off, making it easier to judge distances.
! INSTALLATION!INSTRUCTIONS!
FLTW-7625 Instructions 02-21-17.docx Page 1 of 3 GS
Third Brake Light Cargo Camera
2015-Current Ford F-150, 2017 Ford SuperDuty
(Kit # FLTW-7625)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
Cargo lamp bracket w/camera
Chassis harness
Power/video harness
These instructions
Wire strippers
Wire cutters
Electrical tape
Zip ties
Plastic panel removal tools
Digital Volt Meter / BCM safe test light
Screwdriver
Socket set/wrench
Torx bits
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
! INSTALLATION!INSTRUCTIONS!
FLTW-7625 Instructions 02-21-17.docx Page 2 of 3 GS
1. Remove the factory cargo lamp from the
vehicle by removing the (2) Phillips screws and
lifting from the bottom.
2. Unplug factory connector from the back of the
light.
3. Place the factory cargo lamp on top of the
cargo lamp bracket with camera, and reconnect
the factory cargo lamp connector.
4. Insert the camera harness into the opening in
the roof.
5. From the inside of the vehicle remove the rear
of the headliner to gain access to the camera
harness. (Each vehicle is different, be careful
not to bend the headliner too much to access
the harness).
6. Route the cable forward to the A-pillar of the
vehicle.
7. Remove the (2) covers on the handle to gain
access to the 10mm bolts.
8. Remove the (2) 10mm bolts and route the
harness down the pillar toward the display. (Be
careful of any airbags in the pillar and avoid
routing the harness over the airbag).
! INSTALLATION!INSTRUCTIONS!
FLTW-7625 Instructions 02-21-17.docx Page 3 of 3 GS
9. Connect Chassis Harness to supplied Power
Harness RCA and power plugs.
10. Connect Power Harness male RCA connector to
RCA located on your display.
11. Using a vehicle specific service guide/wiring
diagram and a multi-meter, verify 12V ignition.
RED wire of power harness connects to 12V+
ignition/accessory and BLACK wire of power
harness to black chassis ground nut or wire.
RECOMMENDED: Solder wires and cover with
heat shrink tubing or use T-taps as an optional
connection method.
12. Use wire ties or electrical tape to secure chassis
harness and jumper harness RCA and power
connections.
13. Coil any excess chassis harness and secure it to
existing vehicle wiring with wire ties or
electrical tape.
14. Install the factory cargo lamp with the cargo
lamp bracket with camera behind it. Use the
factory screws.
15. Start the screw in the light about a ¼ inch and
then put on back of vehicle cab and tighten the
screws the rest of the way. (Be sure the foam
gasket is set in the correct place). We are not
responsible for leaks from around the new
lamp.
16. Test system. Check display for the camera
image.
17. Reassemble vehicle. Follow your disassembly
steps in reverse order, taking care not to bind
the harness wiring when reinstalling trim.
!
CAMERA OPTIONS
The camera offers grid lines or no grid lines
and mirror image options for forward-facing
cameras.
Grid line options: Default setting displays grid
lines. To remove the grid line display, connect the
two green wires near the end of the Camera
Harness.
Display options: Default setting is mirror image
display (i.e., words and letters appear backwards
as in a mirror) for rearward facing camera (rear
view) installation. To change to forward facing
camera (front view), connect the two white wires
near the end of the camera harness.
Green and White wires on the Camera Harness
-
1
-
2
-
3
BrandMotion FLTW-7625
The BrandMotion FLTW-7625 is a third brake light cargo camera designed for 2015-Current Ford F-150 and 2017 Ford SuperDuty vehicles. It provides a clear view of the rear or front of your vehicle, depending on how you configure it.
Key features of the FLTW-7625 include:
- Easy installation: The camera simply replaces your existing cargo lamp, making it quick and easy to install.
- Waterproof design: The camera is waterproof, so you can use it in all weather conditions.
- Night vision: The camera has night vision, so you can see clearly even in low-light conditions.
- Grid lines: The camera has grid lines that can be turned on or off, making it easier to judge distances.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
BrandMotion FLTW-7629 Installation guide
-
-
-
-
-
-
-
-
-
Other documents
-
Gentex GENFDM3LN Installation guide
-
Honda 76410-SZA-A01 Installation guide
-
Hyundai L0F62 AU600 Quick Reference Manual
-
Raingler 2005-2015 Nissan Xterra Full Ceiling Net Installation guide
-
Chevrolet Tahoe 2016 User guide
-
-
-
Chevrolet TAHOE POLICE - 2011 User manual
-
Crimestopper Security Products SecurView SV-9155 User manual
-
Ford FCS-15101-10 User manual
