Inspur EIS800 Installation guide

Inspur
Brand
Inspur
Model
EIS800
Type
Installation guide
边缘微服务器堆叠机柜安装指南
Edge Microserver Stacking Cabinet Installation Guide
逆时针旋转两侧天
线，将服务器两侧
天线拆除。
Rotate the
antennas of the
top server
anticlockwise to
remove them.
逆时针松开服务器左右
耳手拧螺丝，将服务器
拉出机柜。
Loosen the
thumbscrews
anticlockwise, and pull
the top server out from
the cabinet.
按照上述步骤，由上而下，
依次将服务器拆卸完成。
Repeat the steps above to
remove the rest 5 servers.
DO remove the server from
top down.
顺时针锁紧服务器左右耳
手拧螺丝，将服务器固定
到机柜上。
Tighten the thumbscrews
on the left and right
mounting ears of the
server clockwise to
secure the server to the
cabinet.
取出服务器天线，将天线顺时
针旋转，固定到服务器两侧。
Align the
antennas with the
holes on both sides
of the cabinet, rotate
them clockwise to secure
them to the server.
自下而上依次安装，至
整个6U服务器机柜安装
完成。
Repeat the steps above
to install the rest 5
servers.
安装服务器
Installing the Server
拆卸服务器
Removing the Server
B015008000000000
对准服务器安装位置（1U的空间），将服务器推入机柜
中（由下而上依次安装）。
Align the server with the corresponding position (1U
space at the bottom of the cabinet), and push it all
the way into the cabinet.
准备好6U服务器安装机柜。
Get the 6U server cabinet ready.
注意：6U机柜安装时需要由下而上依次安装，拆卸时
由上而下依次拆卸。
Note: In a 6U cabinet, install servers from bottom
up and remove in reverse.
1
3
1
2
3
4
5
2
天线孔X12
Antenna hole X12
导轨X8
Rail X8
隔板X1
Partition X1
  • Page 1 1

Inspur EIS800 Installation guide

Inspur
Brand
Inspur
Model
EIS800
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents