2. BrandMotion
  3. AHDS-7650
AHDS-7650

BrandMotion AHDS-7650 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the BrandMotion AHDS-7650 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTALLATION!INSTRUCTIONS!
AHDS-7650 Instructions 7/2/20
Page 1 of 2
KB
5” Digital Display Monitor
(Kit # AHDS-7650)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
5” Display monitor with removable sunshade
Power and Input cable
Video Input Harness
Mounting Bracket
Thumb Screws
Allen Wrench
Aux A/V harness (for front input)
Remote
These Instructions
Electrical tape
Zip ties
Plastic panel removal tools
Digital Volt Meter / BCM safe test light
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
NOTE:
We strive to provide accurate and up-to-date installation instructions. For the latest full color
ins
tructions, as well as an installation video, please visit www.brandmotion.com
INSTALLATION!INSTRUCTIONS!
AHDS-7650 Instructions 7/2/20
Page 2 of 2
KB
1. RED wire connects to accessory power.
2. BLACK wire connects to ground.
3. Connect the appropriate trigger wire to reverse
for the input you intend to use. The BROWN
wire is for the CH1 input, the BLUE wire is for
the CH2 input, and the GRAY wire is for the CH3
input.
4. Connect the power harness to the monitor.
5. Connect the video input harness to the input
you selected when you connected the reverse
trigger wire in step 3. (The BROWN wire is for
the CH1 input, the BLUE wire is for the CH2
input, and the GRAY wire is for the CH3 input.)
6. The Allen wrench is used for screw that allow
you to “lock” the mounting bracket in position.
/