Page is loading ...
INSTALLATION INSTRUCTIONS
7" Digital Quad Display Monitor with DVR
(Kit # AHDS-7674)
Items Included in the Kit:
7” Quad Display Monitor with DVR
Power and Input Box w/ Cable
Video Input Harness
Mounting Stand
Remote
Allen Wrench
4GB SD Card
These instructions
Tools & Supplies Needed:
Electrical tape
Zip Ties
Plastic panel removal tools
Digital Volt Meter / BCM safe test light
Safety Precautions:
● Work in well ventilated area that is clear of obstructions.
● Secure vehicle with tire chucks in both front and rear of tires.
● Turn vehicle accessories OFF and ensure ignition key is in OFF position.
● Wear safety goggles and snug fitting clothes.
AHDS-7674 Instructions 9/28/18 Page 1 of 2 AR
INSTALLATION INSTRUCTIONS
● Use tools only for their intended purpose and which are in good repair.
● Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
Monitor Wire Connections
1. Mount stand in the desired location.
2. The RED wire connects to accessory power.
3. The BLACK wire connects to ground.
4. Connect the power harness to the monitor.
5. Trigger wires trigger the corresponding camera input
a. Trigger 1 → Video 1
b. Trigger 2 → Video 2
c. Trigger 3 → Video 3
d. Trigger 4 → Video 4
6. When wiring the monitor into the vehicle, there may be some applications where you might not have
access to some of the trigger wires. (Left, Right turn signals, Reverse, etc.) When trigger wires are not
available, use a toggle switch to trigger video inputs. Trigger wires are only needed for auto switching
the inputs. Inputs can be manually switched by using the buttons on the monitor.
AHDS-7674 Instructions 9/28/18 Page 2 of 2 AR
/