2. BLOTZ
  3. B15-ME-111

BLOTZ B15-ME-111 Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the In-line Tower. This document provides a step-by-step guide on how to assemble the model, including information on the proper use of glue, the orientation of the angled supports, and the option to attach the door. I'm ready to help if you have any questions about the assembly process or features.
  • What type of glue is required?
    What tool is needed to remove parts from the sprue?
    Is there an optional part?
    How should the angled supports be oriented?
15mm Desert Fort – In-line Tower
B15-ME-111
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue them together as shown above – Note the
angled supports have an arrow on them which
should point upwards.
[Optional] Glue the door into place behind the
doorway.
Add the walkway piece, moving around the model
gently easing each lug into the corresponding hole.
Take the tower sides and roof.
Attach them to the model as shown above.
Add the other two tower sides.
Attach the front wall piece on each side of the
tower.
The finished model.
/