Axema RD-200 User manual

Type
User manual
Axema Access Control AB | Box 90215 | 120 23 Stockholm, Sweden | 08-722 34 40 | info@axema.se | www.axema.se
USB reader RD-200/300
Manual
Updated 2018-11-17
USB reader RD-200/300
Introduction 3
Installing the software 3
Configuration 3
RD200 - EM 3
RD200 & RD300 - Mifare 4
2 (4)
Manual RD200 and RD300
Introduction
The reader is configured to work with VAKA. This manual is only required if the
reader should be reset or used with Axbase3000.
EM: PCPR 1-9028-3
Mifare: PCMIF 1-9028-4
Installing the software
1. Put the supplied disc into a computer.
2. Open the folder
RD200
or
RD300
.
3. Start the program
RD200_RD300_Tools_VXXXX.exe
.
Configuration
RD200 - EM
1. Set the USB reader to PCPR 1-9028-3.
2. Open the USB reader software.
3. Click on
Get Current Setting
.
4. Select
USB Keyboard Emulation
under
USB Mode:
.
5. Select
10H->13D
under
ID Format
for VAKA,
6H->8D
for Axbase.
6. Select
Add Enter (CR)
.
7. End by pressing
Set
to the left of
Get Current Setting
.
8. Select the tab
Command test
and select the field
(Ascii)
.
9. Read a tag and make sure the numbers are correct.
3 (4)
Manual RD200 and RD300
RD200 & RD300 - Mifare
1. Set the USB reader to PDMIF 1-9028-4.
2. Open the USB reader software.
3. Click on
Get Current Setting
.
4. Select
USB Keyboard Emulation
under
USB Mode:
.
5. Select
8H->10D
under
ID Format
for Axema Mifare Classic (AM12345678),
14H->17D
for Mifare DESFire or
8H
for Axbase with Mifare Classic or
DESFire.
When using Axbase, Axema Classic tag has to be read directly to Axbase.
6. Select
Add Enter (CR)
.
7. End by pressing
Set
to the left of
Get Current Setting
.
4 (4)
Manual RD200 and RD300
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Axema RD-200 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI