Axema C30 User manual

C30 Memory Expansion Module

C30 allows VAKAto support up to 4000 users.

Manual

Updated 2018-11-17

C30 Memory Expansion Module

Introduction 3

Mounting and Installation 3

Before you call technical support 3

2 (3)

Manual C30

Introduction

C30 Memory Expansion Module is developed to increase the maximum amount of

people in a VAKA 10 system from 1024 to 4000. Only one C30 is required per sys-

tem.

Mounting and Installation

1. Remove power from the door controller

2. Connect the module to one of the two connectors in the controller and apply

power to the controller.

3. Log in as installer in the VAKA software

4. VAKA will automaticaly detect the new hardware and a dialog (

New

hardware detected

) will appear.

5. Click on the dialog and follow the instructions to install the module.

6. New hardware can also be installed under

Settings

Installation

of Reader / Module

7. Log out and back into VAKA again.

Before you call technical support

The module can be removed and exchanged without loosing any settings.

However, the personal data cannot be administrated while the C30 is unmounted.

3 (3)

Manual C30