2. Warrior Products
  3. 59010

Warrior Products 59010, 59015 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Warrior Products 59010 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Protecting Your Adventure Lifestyle
========================================================================================
QUALITY • INTEGRITY • INNOVATION • SERVICE
Warrior, Inc.
16850 SW Upper Boones Ferry Rd
Ste. A
Durham, OR 97224
Phone: (888) 220-6861
Fax: (503) 692-0364
[email protected]
www.warriorproducts.com
UNIVERSAL BRUSH GUARD
INSTALLATION INSTRUCTIONS
WAR 59000 SERIES
READ ALL INSTRUCTIONS BEFORE PROCEEDING.
1. Position your Warrior Universal Brush Guard on the top flat surface of your
bumper. Take care to center it with mounting brackets adjusted forward or
back to accommodate your particular bumper design.
2. Mark through the mounting brackets for drilling.
3. Remove the Universal Brush Guard and drill 3/8” holes where indicated by
marks. Be sure to use safety glasses.
4. Reposition the Universal Brush Guard over the mounting holes and install
using the 3/8” bolts, washers, and lock nuts provided. Make sure all bolts are
tight.
5. After a test drive, re-check tightness of all bolts and you’re done!
Enjoy your new Universal Brush Guard by Warrior Products!
/