BLOTZ B20-ST-112 Assembly Instructions

20mm Fountain

B20-ST-112

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and

remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Fountain (B20-ST-112)

Remove the two base pieces from the sprue.

Glue them together using the guidelines to align

then correctly.

Next remove the large solid disks and the support

post from the sprue..

Glue the support post to the base (you may find it

easier to glue a small piece of scrap to the

underide of the hole first.) and glue the discs to

the post as shown.

Remove the four rings from the sprue.

Glue these in a stack and attach them to the base.

Take the two semi-cirles from the sprue.

Glue them in place.

Remove the two scalloped pieces from the sprue

along with the top nozzle sections.

Carefully lining up the scalloped pieces, glue these

to the top of the column. Then glue the smaller

discs into place.

This manual is also suitable for

Download PDF