Anova ELV52R Assembly Instruction

Type
Assembly Instruction

This manual is also suitable for

anovafurnishings.com
888.535.5005 tel
TOOLS NEEDED:
9/16" Open end or box end wrench
Assembly Instructions
Elevation
ELV52T- Elevation 52" Round Thermory Table
ELV52R- Elevation 52" Round Recycled Plastic Table
COMPONENT PARTS:
ASSEMBLY HARDWARE: All hardware is stainless steel.
(1) Table Top (4) Table Legs
(4) Sugatsune Glides (12) 3/8" Flat Washers (12) 3/8"-16 Nylon Locknuts
ASSEMBLY: The assembly is a two-person operation.
Inspect the shipping container contents for damage and to determine that all components and hardware are present.1.
2. Lay all parts on a so work surface or on the shipping packaging to prevent damage to nish.
NOTE: Before assembling the nuts to the bolts, it is recommended that a light oil or petroleum jelly be applied to the
screw threads.
1
10/30/2019 Copyright 2019 ANOV Manufactured in the U.S. 2
Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.
3. Locate four table legs and four glides.
4. Insert a glide into the threaded hole at the bottom of a
table leg.
Repeat this step for the remaining table legs.
Table Leg
Glide
Table Leg
3/8"-16
Nylon Locknut
3/8" Flat
Washer
Bolt
5. Locate the table top, twelve 3/8" Flat Washers, twelve
3/8"-16 Nylon Locknuts, and four Table Legs.
6. Place a table leg against the table frame by sliding the leg
onto the three protruding bolts.
7. Place a 3/8" Flat Washer on each of the three threaded
bolts now protruding through the Table Leg.
8. Place a 3/8"-16 Nylon Locknut on each of the three
threaded bolts now protruding through the at washers.
Tighten with a 9/16" open end or box end wrench.
9. Repeat steps 6-8 for each table leg.
  • Page 1 1
  • Page 2 2

Anova ELV52R Assembly Instruction

Type
Assembly Instruction
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI