George Kovacs P8025-084 User manual

Brand
George Kovacs
Model
P8025-084
Type
User manual

George Kovacs P8025-084 is a hanging light fixture with a modern design that can be used to add a touch of elegance to any room. It features a circular strap that mounts to the ceiling and a metal shade that can be adjusted to hang at various heights. The fixture is compatible with xenon bulbs and includes all necessary hardware for installation.

George Kovacs P8025-084 is a hanging light fixture with a modern design that can be used to add a touch of elegance to any room. It features a circular strap that mounts to the ceiling and a metal shade that can be adjusted to hang at various heights. The fixture is compatible with xenon bulbs and includes all necessary hardware for installation.

INSTALLATION INSTRUCTIONS
For Model # P8025-084 (Rev. 08/23/2012)
WARNING! SHUT POWER OFF AT FUSE OR CIRCUI T BRE AKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
HANGING THE FIXTURE (Fig. 1)
1. Shut off power at the circuit breaker and remove
old fixture including the mounting hardware.
2. Carefully remove the fixture from the carton and
check that all parts are included as shown in the
illustration.
3. Secure Circular Strap (B) using Screw (C) to the
Outlet Box. The side of the Circular Strap marked
“GND” must face out.
4. Determine desired distance from ceiling to hang
the Fixture. (Do not mount less than 4 inches from
ceiling). Loosen the Ceiling Metal (I), Run the Wire
Cord through Metal Sleeve (J) and cut redundant
wire, then Place the wire end into the Metal (K)
using the one small Hex Nut to tighten it. And
secure the other big Hex Nut on Metal Sleeve (J)
Put the Ceiling Metal (I) to wrap it using Screws
(H).
CONNECTING THE WIRES (Fig. 2)
5. At this point, connect the electrical wire as shown
in figure 2, making sure that all wire connectors
are secured. If your outlet has a ground wire
(green or bare copper), connect the fixtures
Ground Wire to it. Otherwise, connect the fixture
Ground Wire directly to the crossbar using the
Green Screw provided.
6. Place Canopy (D) over the Circular Strap (B). Turn
the Canopy (D) and let the Stud (A) slide into the
slot of Canopy (D). Tighten the Stud (A).
7. Install Xenon bulb into socket (E) in accordance
with the fixture’s specifications. (DO NOT
EXCEED THE MAXIMUM WATTAGE RATING!).
(NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
8. Loosen the metal ring (L) from socket (E), align the
holes on the metal ring (L) and Glass shade (F)
and secure them by three screws (G). Place glass
shade (F) onto the socket.
Your installation is now complete. Return power
to the junction box and test the fixture.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
WRONG
RIGHT
WARNING!
1. The wire has positive and negative power
cords. To avoid short circuit, please don’t
intercross wire. (See Fig. 3)
2. Avoid swing for children!
LA-1211E
OUTLET BOX
(CEILING)
F
J
K
A
B
C
D
H
G
I
E
L
IMPORTANT: FIXTURE SHOULD BE INSTALLED
BY A QUALIFIED ELECTRICIAN TO ENSURE
PROPER WIRING AND INSTALLATION.
  • Page 1 1

George Kovacs P8025-084 User manual

Brand
George Kovacs
Model
P8025-084
Type
User manual

George Kovacs P8025-084 is a hanging light fixture with a modern design that can be used to add a touch of elegance to any room. It features a circular strap that mounts to the ceiling and a metal shade that can be adjusted to hang at various heights. The fixture is compatible with xenon bulbs and includes all necessary hardware for installation.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents