PANEL2X4 INSTALLATION INSTRUCTIONS

Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.

Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com

SAFETY INSTRUCTIONS

WARNING: Risk of re or electric shock. Suitable for Damp locations.

WARNING: Suitable for 9/16” or 15/16” Flat Tee Grid in both Insulated Ceilings and Non-Insulated Ceilings. Access above

ceiling required.

WARNING: Do not handle energized xture when hands are wet, when standing on wet or damp surfaces, or in water.

WARNING: Vapor barrier must be suitable for 90 C.

Access Plate

Conduit Knockouts

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

RAB xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding

is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A

PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

Make certain power is OFF before installing or maintaining xture.

RECESSED CEILING MOUNTING

The xture is suitable only for INDOOR RECESSED CEILING

2. Firmly bend the pre-installed Grid Clips (4) against the

Tee-Grid Bar to secure the Housing.

3. Support wires are required by Installation Codes.

Support the Housing to the building structure by

Support Wires (supplied by others) through the Grid

Clip Hole.

4. Make sure that the orientation of the Splice Box and

Access Plate faces an accessible tile to make electrical

splices.

5. Loosen Access Plate Screw and remove the Access

abrasion, do not expose wiring to edges of sheet

metal or other sharp objects.

7. Replace Access Plate and tighten Access Plate Screw.

Housing

PANEL2X4 INSTALLATION INSTRUCTIONS

Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.

Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com

CLEANING & MAINTENANCE

CAUTION: Be sure xture temperature is cool enough to

touch. Do not clean or maintain while xture is energized.

1. Clean acrylic lens & xture with non-abrasive cleaning

solution.

2. Do not open xture to clean the LEDs. Do not touch the

LEDs.

ONOFF WIRING

3. Connect the GROUND wire from xture to supply ground.

TROUBLESHOOTING

1. Check that the line voltage at xture is correct. Refer to

wiring directions.

2. Is the xture grounded properly?

Fig. 2

010V DIMMABLE WIRING

Universal voltage driver permits operation at 120V thru

277V, 50 or 60 Hz. 0-10V control wires must be rated for 300V

minimum. For 0-10V Dimming, follow the wiring directions as

the output.

4. Connect the purple xture lead to the (V+) DIM lead.

5. Connect the gray xture lead to the (V-) DIM lead.

6. Cap the yellow xture lead. Do NOT connect.

Note: These instructions do not cover all details or variations in equipment nor do they provide for every possible situation during

installation, operation or maintenance.