HARRRRD L/UC24/16/XU/950/LKM1 Installation guide

Brand: HARRRRD

Model: L/UC24/16/XU/950/LKM1

Type: Installation guide

This manual is also suitable for

L/UC12/16/XU/830/LKM1

Note: All Statements, technical information, and recommendations contained herein are based on information the company believes to be reliable.

The accuracy or completeness thereof is not guaranteed. In accordance with “Terms and Conditions,” and since conditions of use are outside of

the company’s control, the purchaser should determine the suitability of the product for its intended use and assumes all risk and liability

whatsoever in connection herewith.

 RISK OF ELECTRICAL SHOCK. TURN MAIN SWITCH AND CIRCUIT BREAKER TO “OFF” POSITION

BEFORE SERVICE OR RELAMPING.

 All electrical connections must be in accordance with local codes, ordinances and National Electrical Code.

If you are unfamiliar with proper electrical wiring or connections, secure the services of a qualified licensed

electrician.

 Proper grounding of the fixture is essential for protection from shock, correct operation of the electronic

driver and the elimination of electrical interference.

ITEMS PROVIDED

INSTALLATION INSTRUCTIONS

Undercabinet LED Luminaire

08/2019

IMPORTANT: Read carefully before installation and retain for future reference.

Input: 120V

WIRING DIAGRAM

Figure 1A

Lens and Cover Disassembly

Figure 2A

Cable Connector LED Under Cabinet Mounng Screws Wire Nuts

1. Remove Lens by applying pressure to the front of the lens and liing upwards. (Refer to Figure 1A)

2. Remove Cover by applying pressure to the front part of the cover and li cover upwards to clear the tabs on housing. (Refer to

Figure 2A)

1. Remove desired knockout hole by hammering it out with a screw driver and hammer. (Refer to Figure 3A)

2. Install Cable Connector to housing by feeding thru knockout hole and ghtening the nut provided. (Refer to Figure 4A)

3. Secure housing to the boom of the cabinet with mounng screws provided. (Refer to Figure 5A)

4. Feed Input supply wires thru cable connector and ghten cable connector. (Refer to gure 6A)

5. Connect input supply wires to wires on xture Green to Green (Ground ), White to White (Neutral), and Black to Black (Live)

(Refer to Figure7A)

6. Reinstall the Lens and Cover by reversing steps in lens and cover disassembly. (Refer to Figure 1A and 1B)

Installation

Figure 3A

Figure 4A

Figure 5A

Figure 6A

Figure 7A

These instrucons do not claim to cover all details or variaons in the equipment, procedure, or process described, nor to provide direcons for meeng every possible conngency during installaon, operaon or

maintenance. When addional informaon is desired to sasfy a problem not covered suciently for user’s purpose, please contact your nearest representave.