Auto Fill Lever Retro-Fit Kit RFA-35

5029779

REV 07/23/04

If you have any questions concerning this bulletin, please contact Manitowoc Beverage Equipment’s Technical Service Department at (800) 367-4233

This auto fill retro fit kit uses the Walrus auto fill lever which is

black plastic and is more aesthetically pleasing than the ex-

isting stainless steel levers when used in combination with

the A-35 auto fill valves.

NOTE: This kit will not work on valves ordered prior to

1. Remove the lever retaining clip with the ground wire

2. The ground wire will be used in the installation of

the new lever.

3. Cut the connector off of the new lever (#51610) as

fice caps as shown (See Figure 3).