2. Hukoro
  3. F14181-QC

Hukoro F14181-QC User manual

  • Hello! I've reviewed the provided assembly instructions for a light fixture. This document guides you through the installation process, from checking the wiring to mounting the fixture and connecting the electrical components. I'm ready to address your queries about the assembly process.
  • What should I inspect before starting the installation?
    What should I do before installing the fixture?
    Is the light bulb included?
    Where should sealing tape be used?
    What is included in hardware?
Wire
strippers
Ladder Safety
glasses
Electrical
tape
Phillips
screwdriver
PliersFlat blade
screwdriver
CAUTION
Inspect the wire insulation for any cuts,
abrasions, or exposed copper that may have
resulted during shipping. If there is a defect
in the wire, do not attempt installation.
Before starting installation of this fixture or
removal of a previous fixture, disconnect the
power by turning off the circuit breaker or by
removing the fuse at the fuse box.
Bulbs
(not included)
*PARTS SHOWN MAY DIFFER SLIGHTLY PER LIGHT FIXTURE
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED
EXPLODED PARTS INSTALLATION
STEP 1
Unscrew the rubber rings and screws from the mounting unit.
Use the mounting screws to attach the mounting unit
to the junction box.
STEP 2
Screw the threaded pipe and hex nut into the fixture,
then secure it with hex nut.
HARDWARE INCLUDED
Fixture
Screws
Mounting Unit
Mounting Screws
Wire Nuts
Mounting
ScrewsWire NutsScrews
Mounting Unit
Rubber Ring B Rubber Ring A
Rubber
Ring A
Rubber
Ring B
FixtureIron
Iron
Decorative
Nut
Decorative Nut
Cover
Cover
Threaded Pipe
and Hex Nut
Threaded Pipe
and Hex Nut
Nut
Nut
ASSEMBLY INSTRUCTIONS INSTALLATION
NOTICE: Please use caulk in the back plate and wall
mounting surface to prevent water from entering.
STEP 6
Attach the fixture to mounting unit through screw holes as shown,
and secure it with screws.
STEP 7
Install bulbs (not included).
STEP 3
Place the top cover onto the threaded pipe, then secure with
rubber ring A and nut.
STEP 4
Attach the iron to the fixture through screw holes as shown,
and secure it rubber ring B and decorative nut.
Make the electrical connection from the junction box to the fixture.
Connect the ground wire to the mounting unit using the preinstalled
green ground screw. Then, connect the positive, negative and
ground wires with the supplied wire nuts. Secure with electrical tape.
STEP 5
White wire from
the fixture
Ground wire from
the Fixture
Black wire from
the fixture
Black or Red wire (hot)
from the junction box
White wire (neutral)
from the junction box
Bare or Green ground wire
from the junction box
*Green Ground Screw
*Sealing tape
(not included)
/