IST-nDrive

NeuroNexus IST-nDrive User manual

  • I've reviewed the IST-nDrive User Manual and I'm ready to help you with your questions. This document provides step-by-step instructions to prepare and use the nDrive device for implantation. It covers attaching the nDrive assembly, aligning the probe mount and proper cement application for your device.
  • How do I prepare the nDrive initially?
    How to lock the nDrive onto the IST-nDrive?
    Where should I apply cement?
User Manual
IST-nDrive
Updated March 05, 2021
NeuroNexus Technologies, Inc. ©2021 | 5200 S. State Street, Suite 200, Ann Arbor, Michigan USA
Telephone: +1.734.913.8858 | Fax: +1.734.786.0069 | [email protected]
p.2
IST-nDrive
IST-nDrive
Step 1
Step 2
This user manual will show you how to prepare your probe and nDrive for implantation.
Prepare the nDrive, nDrive base,
and IST-nDrive. Do not attach
the probe or probe mount yet.
Loosen the back screw on
the nDrive. Slide the nDrive
assembly onto the IST-nDrive.
NeuroNexus Technologies, Inc. ©2021 | 5200 S. State Street, Suite 200, Ann Arbor, Michigan USA
Telephone: +1.734.913.8858 | Fax: +1.734.786.0069 | [email protected]
p.3
IST-nDrive
Step 3
Step 4
Tighten the screw to lock the
nDrive onto the IST-nDrive.
Align the probe mount with the
front screw.
NeuroNexus Technologies, Inc. ©2021 | 5200 S. State Street, Suite 200, Ann Arbor, Michigan USA
Telephone: +1.734.913.8858 | Fax: +1.734.786.0069 | [email protected]
p.4
IST-nDrive
Step 5
Step 6
Push the front screw through
the larger probe mount
screwhead opening.
Slide the probe mount to the
right and tighten the screw to
lock it in place.
NeuroNexus Technologies, Inc. ©2021 | 5200 S. State Street, Suite 200, Ann Arbor, Michigan USA
Telephone: +1.734.913.8858 | Fax: +1.734.786.0069 | [email protected]
p.5
IST-nDrive
Step 7
Step 8
Place the probe connector into
the connector bracket.
Mount the IST-nDrive on a
stereotaxic frame.
Perform insertion at target
location. Cement the nDrive
base once initial insertion has
been performed.
NOTE: Apply cement to only
the nDrive base, leaving room
to access the screw to release
the nDrive unit after the
experiment.
NeuroNexus Technologies, Inc. ©2021 | 5200 S. State Street, Suite 200, Ann Arbor, Michigan USA
Telephone: +1.734.913.8858 | Fax: +1.734.786.0069 | [email protected]
p.6
IST-nDrive
Step 9
Once the nDrive base has been
cemented, loosen the back
screw and carefully slide the
IST-nDrive away.
NeuroNexus Technologies, Inc. ©2021 | 5200 S. State Street, Suite 200, Ann Arbor, Michigan USA
Telephone: +1.734.913.8858 | Fax: +1.734.786.0069 | [email protected]
/