Stinger UN1880 User guide

Brand: Stinger

Model: UN1880

Category: Car kits

Type: User guide

Products Used

Put down the saw...

Quick and clean install without cutting any of the

vehicle sub-dash or relocating the OnStar/WiFi

module.

2014-2018 Silverado/Sierra

Radio Replacement

StingerElectronics.com

TECH TIP

Stinger ELEV8

(UN1880)

Best Kits: BKGMK325BM

American Intl: GMK325BM

PAC

RP5-GM51

PAC

SAT-01

Remove the center trim panel

around radio display. Remove 4 x

7mm screws and 2 connectors to

remove the factory radio display.

Depending on which factory audio

system is installed (4 or 7”), there

will be 1, 2 or 3 modules behind the

display. FIG A

Unplug and remove the GM Radio

Module. Remove CD/DVD Module if

equipped. The ELEV8 Radio Module

can be installed in the upper space

and the bottom space can be used

for the RP5 module, sat tuner and

any other peripherals. FIG B

Refering to yellow cutline in FIG C,

use your favorite power tool to cut

the plastic dash mount bracket.

Refering to the yellow cut line in FIG

D, cut both side brackets.

Note: For the side brackets, you can

score the plastic with a utility knife

and then break apart.

GM Radio Module

OnStar Module

FIG C

FIG D

R L

CUT OFF APPROX

1.25”

CUT FLUSH

ALONG TAB

FIG B

FIG A

ELEV8 Radio Module

RP5 MODULE, SAT TUNER... ETC

CD/DVD PLAYER

1. Disassembly

2. Prepping the Kit

TECH TIP

1. Attach the Clamp Assembly to the back

of the ELEV8 display using four M4 X 12

screws.

2. Attach display to the plastic dash mount-

ing bracket. The rubber boot will not be

used.

3. Cut and remove center rib from main

bracket and le smooth.

4. Attach the modied left and right side

brackets. Attach ISO spacers to the inside

upper sections on both left and right side

brackets. (Refer to kit instructions for more

information).

Slide the ELEV8 assembly into the the kit. Ad-

just depth and angle to desired position. Use

four #10 X 3/8 coarse thread screws, includ-

ed in the ELEV8 harware pack, to attach

radio mounting bracket to side brackets.

Two screws per side. FIG E

Note: There are multiple mounting holes on

the mounting bracket and side brackets to

allow adjustment and alignment. If needed,

you may drill additional holes in the mount-

ing bracket and/or the dash kit brackets

to align and secure the display in the best

position.

FIG E

1 2

3 4

3. Display & Kit Assembly

4. Display Adjustment & Mounting

Note

In most cases the bottom edge of the display will be

resting on the dash kit. Adding a small piece of felt or

foam tape in the center will ensure there is no squeaks

or rattles.

Do you have ELEV8 install to share?

Send us the details and get some Stinger swag - [email protected]

Stinger UN1880 User guide

Brand: Stinger

Model: UN1880

Category: Car kits

Type: User guide

Download PDF

report

Stinger UN1880 User guide

Stinger UN1880 User guide

Related papers

Other documents