Midmark 630 Barrier-Free® Universal Procedures Table (-001 thru -009) User guide

Brand: Midmark

Model: 630 Barrier-Free® Universal Procedures Table (-001 thru -009)

Category: Multimedia carts & stands

Type: User guide

This manual is also suitable for

230 Universal Procedures Chair

MA749300i

Transportation Cart [9A335]

Contents:

Installation ..............1

Exploded View ........5

Special Tools:

none

003-1508-00 Rev. D

Step 3: Rotate two steer casters to position shown.

Press caster pedlas down to lock position.

Note: The steer casters are located at the open end of the cart.

Intended Use:

To transport Midmark 630 (75/LP / Ritter 230 (75E) tables only.

Caster Pedal

Requirements / Restrictions:

The following accessories must be removed before using cart:

9A144 (Knee Crutches 9A157 (Side Rails) 9A179 (Armboard)

9A182 (Welch-Allyn Bracket) 9A205 (Base Rail) 9A214 (Restraint Strap Bracket)

Step 1: (See requirements / Restrictions box).

Remove accessories if necessary. Run

Tilt Down function to full down position.

Ritter models only

Step 2: Remove thigh pad.

NextNext

2 3

Rubber Bumpers

Caster Pedal

Step 4: Align cart, then roll forward until

rubber bumpers contact table.

Note: Raise / lower base function as necessary

so that cart slides under seat frame.

Step 5: Press caster pedals down

to lock two brake casters

in position.

Note: The brake casters are located at the

handle / strap end of the cart.

Step 7: Attach strap hooks to fot weldment.

Pull straps up to remove slack.

Step 6: Install cross-bar as shown.

To remove transportation cart...

A) Lock brake casters.

B) Activate base Up function until table base contacts floor.

C) Release straps / hooks.

D) Remove cross-bar.

E) Unlock casters, and roll cart away from table.

Caution

Be sure area under table base is clear before

activating Base Up function.

(ex. power cord, feet, etc.)

Base Up

Base Down

Brake Casters

Botton

Rung

Step 8: Activate Base Down function

until table base is just above

bottom rung of cart.

Step 9: Unplug table power cord.

Unlock two brake casters.

Move to desired location.

Note: See page 4 for specific instructions on

transporting the table / cart.

NextNext

BackBack

4 5

029-3523-00 14

1 041-0008-02

Serial Numbers / Dates:

all

9A335001 Transportation Cart

(includes items 1 thru 15)

Item Description Qty.

1 • Nut (8-32) 2

2 • Velcro Loop (2” x 12”) 6

3 • Rectangular Tube Plug 2

4 • Screw (10-24 x 3/8”) 4

5 • Bumper 2

6 • Square Tube Plug 4

7 • Steering Caster 2

8 • Screw (5/16-18x x 1/2”) 12

9 • Cart Frame Weldment 1

10 • Brake Caster 2

11 • Clevis Pin 2

12 • E-ring 2

13 • Nameplate 1

14 • Strap / Buckle / Hook Assembly 2

15 • Crossbar (later models only) 1

Tips for transportating the cart / table:

 •Thecartmaneuversbestwhenpulled.

 •Positionthecasterssothatthey“trail”thecartasshown.

 •Lockthesteercastersinthestraightposition,while

allowing the brake casters to rotate feeely.

When transportating cart / table in a moving vehicle...

 •Allcastersmustbelocked.

 •Usecargostrapstosecurecarttotie-downanchors.

Note: It may be necessary to lower back section prior to loading.

Brake Casters

Steer Casters

2 053-0105-13

3 053-1504-00

4 040-0010-47

5 053-1544-00

6 053-1543-00

7 016-1008-01

040-0312-74 8

030-1553-00-312 9

042-0606-05 11

042-0007-03 12

061-0860-01 13

15 050-6891-00-312

016-1008-00 10

NextNext

BackBack

Midmark 630 Barrier-Free® Universal Procedures Table (-001 thru -009) User guide

Brand: Midmark

Model: 630 Barrier-Free® Universal Procedures Table (-001 thru -009)

Category: Multimedia carts & stands

Type: User guide

This manual is also suitable for

230 Universal Procedures Chair

Download PDF

report

Midmark 630 Barrier-Free® Universal Procedures Table (-001 thru -009) User guide

This manual is also suitable for

Midmark 630 Barrier-Free® Universal Procedures Table (-001 thru -009) User guide

Related papers

Other documents