Midmark 253 LED Exam Light Installation guide

Type
Installation guide
1
Rail Mount System [9A457, 9A622]
003-2183-00 Rev. BA2 10/25/18
Intended Use:
To mount Ritter 253 exam light to chair base rail.
Compatible with:
Ritter 253 Exam Light
Restrictions:
Cannot be mounted on same side as 9A328 Chair Arm, or
9A227 Seat Rail.
MA8259i
Plastic Plugs
Foot End of Chair
Step 1: Install base rails.
A) Move all chair functions to full UP position.
B) Remove plastic plugs from mounting holes.
C) Position LH base rail as shown, then secure with three screws.
D) Repeat for RH base rail.
© Midmark Corporation 2010 Style A
2
Step 3: Install rail mount assembly.
A) Slide rail mount weldment onto base rail as shown.
B) Install T-knob. (Tighten to secure weldment in place).
Step 2: Install light & cord restraint.
A) Align light with holes in mounting plate.
B) Secure light by installing two screws thru the top holes.
C) Position cord restraint, then install two bottom screws.
MA8190i
Cord Restraint
T-knob
MA8201i
Protective Film
Before using light:
Remove protective lm from lens.
  • Page 1 1
  • Page 2 2

Midmark 253 LED Exam Light Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI