Midmark 230 Universal Procedures Chair User guide

Category
Multimedia carts & stands
Type
User guide

Midmark 230 Universal Procedures Chair provides versatile positioning and exceptional access for a wide range of procedures. Its 360-degree rotation, coupled with its articulating backrest, allows for quick and easy positioning. The chair's adjustable height range and stirrups enable effortless patient entry and exit. Enhanced infection control features, including a removable and autoclavable upholstery, facilitate efficient cleaning and disinfection.

Midmark 230 Universal Procedures Chair provides versatile positioning and exceptional access for a wide range of procedures. Its 360-degree rotation, coupled with its articulating backrest, allows for quick and easy positioning. The chair's adjustable height range and stirrups enable effortless patient entry and exit. Enhanced infection control features, including a removable and autoclavable upholstery, facilitate efficient cleaning and disinfection.

© Midmark Corporation 2008
1
MA749300i
Transportation Cart [9A335]
Contents:
Installation ..............1
Exploded View ........5
Special Tools:
none
003-1508-00 Rev. D
Step 3: Rotate two steer casters to position shown.
Press caster pedlas down to lock position.
Note: The steer casters are located at the open end of the cart.
Intended Use:
To transport Midmark 630 (75/LP / Ritter 230 (75E) tables only.
Caster Pedal
Requirements / Restrictions:
The following accessories must be removed before using cart:
9A144 (Knee Crutches 9A157 (Side Rails) 9A179 (Armboard)
9A182 (Welch-Allyn Bracket) 9A205 (Base Rail) 9A214 (Restraint Strap Bracket)
Step 1: (See requirements / Restrictions box).
Remove accessories if necessary. Run
Tilt Down function to full down position.
Ritter models only
Step 2: Remove thigh pad.
NextNext
© Midmark Corporation 2008 © Midmark Corporation 2008
2 3
Rubber Bumpers
Caster Pedal
Step 4: Align cart, then roll forward until
rubber bumpers contact table.
Note: Raise / lower base function as necessary
so that cart slides under seat frame.
Step 5: Press caster pedals down
to lock two brake casters
in position.
Note: The brake casters are located at the
handle / strap end of the cart.
Step 7: Attach strap hooks to fot weldment.
Pull straps up to remove slack.
Step 6: Install cross-bar as shown.
To remove transportation cart...
A) Lock brake casters.
B) Activate base Up function until table base contacts floor.
C) Release straps / hooks.
D) Remove cross-bar.
E) Unlock casters, and roll cart away from table.
Caution
Be sure area under table base is clear before
activating Base Up function.
(ex. power cord, feet, etc.)
Base Up
Base Down
Brake Casters
Botton
Rung
Step 8: Activate Base Down function
until table base is just above
bottom rung of cart.
Step 9: Unplug table power cord.
Unlock two brake casters.
Move to desired location.
Note: See page 4 for specific instructions on
transporting the table / cart.
NextNext
NextNext
BackBack
BackBack
© Midmark Corporation 2008 © Midmark Corporation 2008
4 5
029-3523-00 14
1 041-0008-02
Serial Numbers / Dates:
all
9A335001 Transportation Cart
(includes items 1 thru 15)
Item Description Qty.
1 • Nut (8-32) 2
2 • Velcro Loop (2” x 12”) 6
3 • Rectangular Tube Plug 2
4 • Screw (10-24 x 3/8”) 4
5 • Bumper 2
6 • Square Tube Plug 4
7 • Steering Caster 2
8 • Screw (5/16-18x x 1/2”) 12
9 • Cart Frame Weldment 1
10 • Brake Caster 2
11 • Clevis Pin 2
12 • E-ring 2
13 • Nameplate 1
14 • Strap / Buckle / Hook Assembly 2
15 • Crossbar (later models only) 1
Tips for transportating the cart / table:
•Thecartmaneuversbestwhenpulled.
•Positionthecasterssothatthey“trail”thecartasshown.
•Lockthesteercastersinthestraightposition,while
allowing the brake casters to rotate feeely.
When transportating cart / table in a moving vehicle...
•Allcastersmustbelocked.
•Usecargostrapstosecurecarttotie-downanchors.
Note: It may be necessary to lower back section prior to loading.
Brake Casters
Steer Casters
2 053-0105-13
3 053-1504-00
4 040-0010-47
5 053-1544-00
6 053-1543-00
7 016-1008-01
040-0312-74 8
030-1553-00-312 9
042-0606-05 11
042-0007-03 12
061-0860-01 13
15 050-6891-00-312
016-1008-00 10
NextNext
NextNext
BackBack
BackBack
  • Page 1 1
  • Page 2 2
  • Page 3 3

Midmark 230 Universal Procedures Chair User guide

Category
Multimedia carts & stands
Type
User guide

Midmark 230 Universal Procedures Chair provides versatile positioning and exceptional access for a wide range of procedures. Its 360-degree rotation, coupled with its articulating backrest, allows for quick and easy positioning. The chair's adjustable height range and stirrups enable effortless patient entry and exit. Enhanced infection control features, including a removable and autoclavable upholstery, facilitate efficient cleaning and disinfection.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI