VA-80AB
SANYO Electric Co.
,
Ltd.
G 1-1/2
-Make sure to also consult the relevant intsruction manuals.
-Use G 1-1/2 female screw thread bracket only. No exception.
-No excessive impact during/after installation.
-No modification applied to the thread of VA-80AB.
-Make sure that the attachment firmly is inserted to the bracket.
<NOTE>
For Indoo
r
1)
Fasten supplied bolts (E) loosely at two diagonal
points.
2)
Thread the bolts(E) loosely fastened in step 1) through
VA-80AB's bolt holes(F) with sticker(A') aligned with
sticker(A) and turn the attachment clockwise.
3)
Put the remaining bolts(E) to the other attachment bolt
holes and tighten all the 4 bolts securely.
-To fix the attachment, use the hexagonal wrench
supplied with the attachment, VA-80A.
-Make sure that the attachment is fixed firmly.
φ96(3.8)
For Outdoo
r
*When installing outdoor, please take neccesary and
thorough measures to ensure the camera unit is properly
sealed from inclement weather.
1)
Place the supplied waterproof gasket (C) on top
of the outdoor housing and fasten supplied bolts
(D) loosely at two diagonal point.
2)
Thread the bolts (D) loosely fastened in step 1)
through the attachment bolt holes (E) with sticker
(A') aligned with sticker (A) and turn the
attachment clockwise.
3)
Put the remaining bolts (D) to the other
attachment holes and tighten the bolts (D)
securely.
-To fix the housing, use the hexagonal wrench
supplied with the housing, VA-80EX.
-Make sure that the housin
g
is fixed firml
y
.
<NOTE>
/
