Clover TFT1904DVR Setup Manual

Brand
Clover
Model
TFT1904DVR
Category
Security camera accessories
Type
Setup Manual
SYSTEM INSTALLATION
MONITOR
Press and hold the “PUSH” button on the monitor base until getting the proper angle of
panel (screen) for viewing.
GETTING CONNECTED
1. Video Input (CAM1, CAM2, CAM3 and CAM4)
Connect the cameras to the video inputs on the rear of the TFT monitor as
follows.
Connect a BNC cable (not included) to other device such as slave monitor or other
equipments, if need arises.
3. Audio In (RCA)
Plug a microphone into the RCA jack.
3. LAN
Connect the provided RJ-45 cable for internet networking.
5. RS-485
Terminal for P/T/Z control. The protocol must be compatible with Pelco-D.
6. Alarm Input
4-Alarm sensor input terminal. Connect Normally Open (N. O.) type only.
7. G (Ground)
Common ground terminal to connect Alarm Sensor.
8. Alarm Output
Trigger output when Alarm or Motion activates. N.O or N.C available.
9. Power (DC jack)
Plug the provided AC power supply to the DC jack.
10. Hard Disk Drive (HDD)
Factory installed a 160GB of HDD.
CAMERA
This product can be installed up to 4 cameras.
Connect the provided cameras (6 Pin Din) to the CAM1~4 on the back panel of the product.
AUDIO
The system includes two indoor cameras built-in Audio and two outdoor camera (without Audio)
built-in IR LEDs (Infrared) to view objects in the darkness. Install two indoor cameras to any
channel and select one of the corresponding channel with A-SEL button on the front panel to
record the audio along with video signal or communicate with others where the camera is
installed
  • Page 1 1
  • Page 2 2
  • Page 3 3

Clover TFT1904DVR Setup Manual

Brand
Clover
Model
TFT1904DVR
Category
Security camera accessories
Type
Setup Manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents