2. Extron
  3. TMK 110 D

Extron TMK 110 D User manual

  • Hello! I am an AI chatbot trained to assist you with the Extron TMK 110 D User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
TMK 110 D Installation Guide
The TMK 110 D table mount kit allows under-table installation for single-gang decorator-style
modules. The kit secures AV and control modules close against a furniture surface. Multiple TMK
kits can be mounted side-by-side for greater capacity.
ATTENTION: Do not drill through the table or furniture. If the table is too thin or made of
a different material for the supplied screws, use an appropriate type and length.
Mount the TMK 110 D as follows:
TMK 110 D Installation Guide, Continued
68-3114-50 Rev. B
04 17
Extron USA - West -
Headquarters
+800.633.9876
Inside USA/Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA/Canada Only
+1.919.850.1000
+1.919.850.1001 FAX
Extron Europe
800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
Extron China
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Australia
+61.8.8113.6800
+61.8.8351.2511 FAX
© 2017 Extron® Electronics. All rights reserved. www.extron.com
HDMI IN
AUDIO IN
(2)
#8 x 1/2" (2)
Wood Screws
Mark the two keyhole locations at
the desired mounting location.
Drill 3/32-inch (2.4 mm) diameter pilot holes.
Install the two #6 x 1/2-inch wood
screws (provided) into the pilot holes.
Tighten until 1/4 inch protudes.
Install module in the faceplate using the provided hardware.
Slide the faceplate onto the
screws and tighten until secure.
1
2
3
4
Faceplate
HDMI IN
AUDIO IN
HDMI IN
AUDIO IN
Tighten
Tighten
5
HDMI IN
AUDIO IN
(2)
#8 x 1/2" (2)
Wood Screws
Mark the two keyhole locations at
the desired mounting location.
Drill 3/32-inch (2.4 mm) diameter pilot holes.
Install the two #6 x 1/2-inch wood
screws (provided) into the pilot holes.
Tighten until 1/4 inch protudes.
Install module in the faceplate using the provided hardware.
Slide the faceplate onto the
screws and tighten until secure.
1
2
3
4
Faceplate
HDMI IN
AUDIO IN
HDMI IN
AUDIO IN
Tighten
Tighten
5
/