HP RP9 Integrated Dual-Head MSR Installation guide

Brand: HP

Model: RP9 Integrated Dual-Head MSR

Type: Installation guide

Installation Instructions

HP RP9 Integrated

Dual-Head Magnetic

Stripe Reader (MSR)

The information contained herein is subject to change

without notice.

Printed in

First Edition: July 2016

*908079-001*

908079-001

Before you begin

1. Turn off the computer properly through the

operating system, and turn off any external devices.

2. Disconnect the power cord from the AC outlet and

disconnect any external devices.

WARNING! To avoid the risk of serious injury or

damage to the system, make sure that the power

cord is unplugged from the AC outlet at the wall

before installing this product. Failure to do so may

expose you to the risk of electric shock.

NO TE: For regulatory and safety notices, refer to

the Product Notices included with your product. The

regulatory model number for this product is TPC-

W040-MSR.

Contact support

To resolve a hardware or software problem, go to

www.hp.com/support. Use this site to get more

information about your product, including links to

discussion forums and instructions on troubleshooting.

You can also find information on how to contact HP and

open a support case.

NOTE: If you need help preparing your computer model

for this installation, refer to the documentation provided

with the computer, or go to www.hp.com/support to

locate the manual for your model.

Installing the MSR

You can install the MSR in the USB port on the left or right side

of the RP9 display head. Before installing the MSR, you must

remove the display head rear cover and the side port cover.

1. Press the two latches on the display head rear cover

outward 1. Slide the rear cover up, and then lift it off the

display head 2.

2. Remove the two screws that secure the side port cover 1,

and then pull the port cover off the display head 2.

NOTE: You may need to gently loosen the port cover

from inside of the screw holes with a flat-bladed

screwdriver.

3. Insert the USB connector on the MSR into the side USB

port 1, and then secure the module with the two screws

that were previously removed 2.

4. Align the tabs on the display head rear cover with the

slots on the display head. Place the cover on the display

head, and then slide the cover down so that it snaps in

place.

5. Reconnect the power cord and any external devices, and

then turn on the computer.

Configuring the MSR

To configure the integrated MSR, refer to the HP Point of Sale

Configuration Guide (available in English only). The guide is

located with the documentation on your retail computer and at

www.hp.com/support. To access the guide on the retail

computer, select Start > HP Point of Sale Information.

Documentation feedback

HP is committed to providing documentation that meets your

needs. To help us improve the documentation, please send any

suggestions, comments, or errors to doc.fee[email protected].

Include the document title and part number (located near the

barcode) when submitting your feedback.

HP RP9 Integrated Dual-Head MSR Installation guide

HP RP9 Integrated Dual-Head MSR Installation guide

HP RP9 Integrated Dual-Head MSR Installation guide

Related papers

Other documents