PK-5 - Electrode Dryer
1 (1) www.esab.com
Use
The unit is intended for drying and storing welding electrodes in the temperature range 70-300
o
C.
The unit is to be used only in accordance with these instructions. Is must not be used for any other
purpose because of possible injuries or material damage.
Before use
Check the unit for transport damage; do not connect a faulty unit to the mains. Check that the
voltage and frequency marked on the rating plate match the values of the mains to which the unit is
to be connected.
Location
To avoid overheating, the clearance to any material must be no less than 0,5 m on any side and no
less than 1 m above the unit. Make sure that there are no obstacles and no flammable material closer
to the unit. The unit must never be covered. Place the unit on a flat surface. The unit may not be
used in environments where there is danger of explosion (EX).
Using the unit
Do not load the cabinet with packaged electrodes, they must be taken out of their package first.
Connect the unit to the mains by plugging it into the wall socket. The red pilot light is lit whenever
the unit is connected to the mains. Select the drying temperature according to the recommendations
of the manufacturer of the electrodes. When the unit has reached the temperature set, continue
drying according to the instructions of the manufacturer. Unnecessary opening of the lid and
addition of new electrodes prolong the drying process.
Remove the plug from the socket when the cabinet is not in use.
Specification
Voltage 230 V / 50 Hz
Power 500 W
Storage temperature 70 - 300
o
C
Capacity 3-4 packages of electrodes
Outer diameter/height 345 / 650 mm
Weight 13 kg
Equipment thermostat, thermometer, pilot light
ESAB AB Made by: Ergi Oy
SE – 695 81 Laxå Finland
Phone: +46 584 81000 phone: +358-9-753 8005
Fax: +46 584 13056 fax: +358-9-753 8460
/