ESAB PK 1 Electrode cabinet User manual

PK-1 - Electrode Cabinet

1 (1) www.esab.com

Use

The unit is intended for storing welding electrodes at the temperature 100-110

C, at which

temperature the welding electrodes remain usable for 6-7 hours, depending on conditions. The unit

is to be used only in accordance with these instructions. Is must not be used for any other purpose

because of possible injuries or material damage.

Before use

Check the unit for transport damage; do not connect a faulty unit to the mains. Check that the

voltage and frequency marked on the rating plate match the values of the mains to which the unit is

to be connected.

Location

To avoid overheating, the clearance to any material must be no less than 0,5 m on any side and no

less than 1 m above the unit. Make sure that there are no obstacles and no flammable material closer

to the unit. The unit must never be covered. Place the unit on a flat surface. The unit may not be

used in environments where there is danger of explosion (EX).

Using the unit

Do not load the cabinet with packaged electrodes, they must be taken out of their package first.

Connect the unit to the mains by plugging it into the wall socket. The red pilot light is lit whenever

the unit is connected to the mains. Load the cabinet with dry electrodes only, the cabinet is not

usable for drying welding electrodes. Do not open the lid unless necessary, as it shortens the time

the electrodes are usable before drying.

Remove the plug from the socket when the cabinet is not in use.

Specification

Voltage 230V / 50 Hz

Power 100 W

Storage temperature approx. 100

Capacity approx. 1.5 packages of electrodes

Outer diameter/height 225/610 mm

Weight 6 kg

Equipment pilot light

ESAB AB Made by: Ergi Oy

SE – 695 81 Laxå Finland

Phone: +46 584 81000 phone: +358-9-753 8005

Fax: +46 584 13056 fax: +358-9-753 8460