FMI VTD-30PV-JHB Owner's manual

Brand: FMI

Model: VTD-30PV-JHB

Type: Owner's manual

APPROVED

TESTED AND

LISTED BY

The OF-RC Kit Contains the following:

• 1-On/OffRemoteControlKitHRC100

• 2-Battery9V 111836-01

For more information, visit www.desatech.com

OF-RC (ON/OFF) REMOTE

CONVERSION KIT

For All Millivolt Cascade Natural and

Propane/LP Gas Logs

(NOT A GAS CONVERSION KIT)

ANSI Z21.60

CSA 2.26

• 1-Bracket 117074-01

• 2-Screw8-32x3/8" 111782-01

• 1-Instructionmanual 114370-04

WARNING: This conversion kit shall be installed

by a qualied service agency in accordance with the

manufacturer's instructions and all applicable codes and

requirements of the authority having jurisdiction. The

information on this instruction must be followed to mini-

mize the risk of re or explosion or to prevent property

damage, personal injury or death. The qualied service

agency performing this work assumes responsibility for

the proper conversion of this appliance with this kit.

WARNING: If the information in this manual is not

followed exactly, a re or explosion may result causing

property damage, personal injury or loss of life.

WARNING: Improper installation, adjustment, al-

teration, service or maintenance can cause injury or

property damage. Refer to this manual for correct in-

stallation and operational procedures. For assistance

or additional information consult a qualied installer,

service agency or the gas supplier.

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.

www.desatech.com

114370-04B2

Figure 3 - Connecting Wire Terminals

Control

Valve

INSTALLATION

ThisOF-RCOn/OffRemoteKitisdesignedto

beusedonMVCascadeseriesVTD-18NV-

JHB,VTD-18PV-JHB,VTD-24NV-JHB,VTD-

24PV-JHB,VTD-30NV-JHBandVTD-30PV-

JHB.ThiscanalsobeusedonMVCascade

seriesthathasbeenconvertedtoHi-Loknob

VTD-HLCNandVTD-HLCP.

Installation Items Needed

Beforeinstallingthekit,makesureyouhave

theitemslistedbelow.

• Phillipsscrewdriver

• needlenoseplier

• 5/16"socketoratheadscrewdriver

OF-RC Conversion Kit or Replacement

Instructions

1. TurncontrolknobtotheOFFposition,and

shutoffgassupplytovalve.

2. Remove4screwsandfaceplate.See

Figure1.

3. Disconnectmanualswitchterminals.This

switchwillbereplacedbyOF-RCremote

kit.Discarddisconnectedswitchwiresor

position and secureto avoid contacting

withotherconnectorsandwires.

4. Install included 9V battery into receiver

(seeFigure2).

5. Connectthe"+"(positive)terminalofre-

ceivertoTHterminalofgasvalveandthe

"-"(negative)terminalofreceivertoTPTH

terminalofgasvalve(seeFigure3).

6. Installincluded9Vbatteryintohandheld

transmitter(seeFigure4).

7. Installreceiverusingincludedbracketand

screws(seeFigure5).

8. Reinstallfaceplateandscrews.

Figure 2 - Installing Battery into Receiver

Figure 1 - Removing Face Plate

Figure 5 - Installing Receiver and

Faceplate

9VBattery

Backof

Receiver

Screws

Faceplate

Screws

9-VoltBattery

Battery

Housing

Figure 4 - Installing Battery in Hand-Held

Remote Control Unit

Battery

Cover

Terminal

Wires

RemoteControlUnit

Faceplate

Bracket

Receiver

GasValve

www.desatech.com

3114370-04B

OPERATING REMOTE

NOTICE: You must light the pi-

lot before using the hand held

remote control unit. Refer to

Lighting Instructions in your

appliance owner’s manual.

1. Afterlighting,letpilotameburnforabout

oneminute.TurncontrolknobtotheON

position.Adjust ame adjustment knob

anywherebetweenHIandLOonmodels

withHi/Loknobconversion.Slideselector

switchtotheREMOTEposition.

Note: Burners may light if hand-held

remote ON button was on when selector

switch was last turned off. You can now

turn the burners on and off with the hand-

held remote control unit.

IMPORTANT:Donotleave the selector

switch in the REMOTE or ON position

whenthepilotisnotlit.Thiswilldrainthe

battery.

2. On/Off Operation: Holdcontrolbuttonon

hand-heldremote until burner turns on.

Holdcontrolbuttonagainuntilburnerturns

off(seeFigure6).Whenturningburners

off,thepilotwillremainlit.

To Lock:Pressbothbuttonsonhand-held

remote control untillight stops ashing.

Hand-heldremotecontrolisnowlocked.If

reisonitwillbeturnedoffautomatically.

Inthelockedstate,lightwillnotlightup

whenanybuttonispressed.

To Unlock:Pressbothbuttonstogether

on hand-held remote control until light

stopsashing.Thehand-heldremoteis

nowunlocked.

IMPORTANT:BesuretopressON/OFF

buttonsonhand-heldremotecontrolunit

for up to 3 seconds to assure proper

operation.

Figure 6 - ON/OFF Hand-Held Remote

Control Unit

Control

Button

IndicatorLight

114370-04

Rev.B

05/08

NOTAUPC

11437004

DESAHeating,LLC

2701IndustrialDrive

BowlingGreen,KY42101

www.desatech.com

1-866-672-6040

FMI VTD-30PV-JHB Owner's manual

FMI VTD-30PV-JHB Owner's manual

FMI VTD-30PV-JHB Owner's manual

Related papers

Other documents