www.desatech.com
Piezo
Figure 12 - Control Knob in OFF Position
OPERATION
WARNING: If you do not fol-
-
-
Operation
WARNING: Do not force the
Use only your hand to turn the
LIGHTING
INSTRUCTIONS
-
wise
-
-
TO APPLIANCE
to
OPERATING
REMOTE CONTROL
Note: To operate appliance with remote
control, it is necessary that the pilot ame be
lit and that the thermopile is hot enough to
supply the power required by the gas valve.
The gas valve control knob must be in the
ON position.
Note: The receiver has a temporary memory
to store the commands sent by the remote
control. When a command is received, an
acoustic signal is sounded. The command
will be executed as soon as allowed by the
control logic of the receiver. Commands given
too quickly after the unit is turned on or off may
not be executed immediately.
Turn On Appliance
-
Note: The ame height will be at maximum
for 5 seconds to allow proper ignition of the
burner. The receiver will not recognize an
increase or decrease for the ame height
during this 5 seconds.
Turn Off Appliance