VTD-18NV-JHB

Desa VTD-18NV-JHB Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Desa VTD-18NV-JHB Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
APPROVED
TESTED AND
LISTED BY
The OF-RC Kit Contains the following:
• 1-On/OffRemoteControlKitHRC100
• 2-Battery9V 111836-01
For more information, visit www.desatech.com
OF-RC (ON/OFF) REMOTE
CONVERSION KIT
For All Millivolt Cascade Natural and
Propane/LP Gas Logs
(NOT A GAS CONVERSION KIT)
ANSI Z21.60
CSA 2.26
• 1-Bracket 117074-01
• 2-Screw8-32x3/8" 111782-01
• 1-Instructionmanual 114370-04
WARNING: This conversion kit shall be installed
by a qualied service agency in accordance with the
manufacturer's instructions and all applicable codes and
requirements of the authority having jurisdiction. The
information on this instruction must be followed to mini-
mize the risk of re or explosion or to prevent property
damage, personal injury or death. The qualied service
agency performing this work assumes responsibility for
the proper conversion of this appliance with this kit.
WARNING: If the information in this manual is not
followed exactly, a re or explosion may result causing
property damage, personal injury or loss of life.
WARNING: Improper installation, adjustment, al-
teration, service or maintenance can cause injury or
property damage. Refer to this manual for correct in-
stallation and operational procedures. For assistance
or additional information consult a qualied installer,
service agency or the gas supplier.
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
www.desatech.com
114370-04B2
Figure 3 - Connecting Wire Terminals
Control
Valve
INSTALLATION
ThisOF-RCOn/OffRemoteKitisdesignedto
beusedonMVCascadeseriesVTD-18NV-
JHB,VTD-18PV-JHB,VTD-24NV-JHB,VTD-
24PV-JHB,VTD-30NV-JHBandVTD-30PV-
JHB.ThiscanalsobeusedonMVCascade
seriesthathasbeenconvertedtoHi-Loknob
VTD-HLCNandVTD-HLCP.
Installation Items Needed
Beforeinstallingthekit,makesureyouhave
theitemslistedbelow.
• Phillipsscrewdriver
• needlenoseplier
• 5/16"socketoratheadscrewdriver
OF-RC Conversion Kit or Replacement
Instructions
1. TurncontrolknobtotheOFFposition,and
shutoffgassupplytovalve.
2. Remove4screwsandfaceplate.See
Figure1.
3. Disconnectmanualswitchterminals.This
switchwillbereplacedbyOF-RCremote
kit.Discarddisconnectedswitchwiresor
position and secureto avoid contacting
withotherconnectorsandwires.
4. Install included 9V battery into receiver
(seeFigure2).
5. Connectthe"+"(positive)terminalofre-
ceivertoTHterminalofgasvalveandthe
"-"(negative)terminalofreceivertoTPTH
terminalofgasvalve(seeFigure3).
6. Installincluded9Vbatteryintohandheld
transmitter(seeFigure4).
7. Installreceiverusingincludedbracketand
screws(seeFigure5).
8. Reinstallfaceplateandscrews.
Figure 2 - Installing Battery into Receiver
Figure 1 - Removing Face Plate
Figure 5 - Installing Receiver and
Faceplate
9VBattery
Backof
Receiver
Screws
Faceplate
Screws
9-VoltBattery
Battery
Housing
Figure 4 - Installing Battery in Hand-Held
Remote Control Unit
Battery
Cover
Terminal
Wires
RemoteControlUnit
Faceplate
Bracket
Receiver
GasValve
GasValve
www.desatech.com
3114370-04B
OPERATING REMOTE
NOTICE: You must light the pi-
lot before using the hand held
remote control unit. Refer to
Lighting Instructions in your
appliance owners manual.
1. Afterlighting,letpilotameburnforabout
oneminute.TurncontrolknobtotheON
position.Adjust ame adjustment knob
anywherebetweenHIandLOonmodels
withHi/Loknobconversion.Slideselector
switchtotheREMOTEposition.
Note: Burners may light if hand-held
remote ON button was on when selector
switch was last turned off. You can now
turn the burners on and off with the hand-
held remote control unit.
IMPORTANT:Donotleave the selector
switch in the REMOTE or ON position
whenthepilotisnotlit.Thiswilldrainthe
battery.
2. On/Off Operation: Holdcontrolbuttonon
hand-heldremote until burner turns on.
Holdcontrolbuttonagainuntilburnerturns
off(seeFigure6).Whenturningburners
off,thepilotwillremainlit.
To Lock:Pressbothbuttonsonhand-held
remote control untillight stops ashing.
Hand-heldremotecontrolisnowlocked.If
reisonitwillbeturnedoffautomatically.
Inthelockedstate,lightwillnotlightup
whenanybuttonispressed.
To Unlock:Pressbothbuttonstogether
on hand-held remote control until light
stopsashing.Thehand-heldremoteis
nowunlocked.
IMPORTANT:BesuretopressON/OFF
buttonsonhand-heldremotecontrolunit
for up to 3 seconds to assure proper
operation.
Figure 6 - ON/OFF Hand-Held Remote
Control Unit
Control
Button
IndicatorLight
114370-04
Rev.B
05/08
NOTAUPC
11437004
DESAHeating,LLC
2701IndustrialDrive
BowlingGreen,KY42101
www.desatech.com
1-866-672-6040
/