FSR PWB-320-Tr, PWB-320-Cv Owner's manual

  • Hello! I've reviewed the installation instructions for the FSR PWB-320-TR and PWB-320-CV Trim Ring & Cover. The document outlines the steps to install the trim ring and secure it to a wall box using screws, and how to attach the cover using snap-top fasteners. I'm ready to answer your questions about this installation process.
  • How many screws are used to install the trim ring?
    What is the size of the screws?
    How is the cover attached?
    Where are the cable exit/vent openings located on the cover?
FSR
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
43276 LIT1658
PWB-320-TR / PWB-320-CV Trim Ring & Cover Installation Instructions
INSTALL (6) #6-32 SCREWS AS SHOWN. LEAVE 1/8" GAP
BETWEEN BOX AND SCREW HEAD.
1.
(6) #6-32 x 1/4" LG
PAN HEAD SCREW
(SUPPLIED)
PWB-320-BX /
PWB-323-BX
INSTALLED
IN WALL
2. INSTALL TRIM RING AND SECURE TO BOX BY
TIGHTENING SCREWS.
TRIM RING
3. PLACE COVER ONTO TRIM RING WITH CABLE EXIT/VENT
OPENING TOWARD TOP AND BOTTOM. PRESS IN ON THE
SNAP-TOP FASTENERS TO AFIX COVER.
COVER
TOP
BOTTOM
/