Detail 1
Detail 2
Detail 3
1
Assembly Instructions
INDUSTRIAL
WORKBENCH
HT-5 9 6 6
IMPORTANT: BEFORE USING OR ASSEMBLING THIS
PRODUCT READ THESE INSTRUCTIONS WITH CARE.
Failure to abide by these instruction and safety rules may
cause poor product performance and/or failure of the product.
1. Workbench must be assembled & used on a level surface.
2. Evenly distribute the weight of load on each level, place the
heaviest items on the bottom shelf. DO NOT OVERLOAD.
3. DO NOT STAND ON OR USE THE UNIT AS A LADDER.
Step 1: Assemble the two frames (item 5) and two beams
(item 3). Start the assembly from the bottom, one
frame at a time. Refer to Detail 1.
Step 2: Assemble the top beams. Be sure that the beam clip
is secured at the bottom part of the slot. Hit the beams
near the joint with the rubber mallet to lock into place.
Step 3: Mount the support (item 4) between two beams.
Each beam has a hole in the center of the ledge
of the beam. Insert the screw from the top and
screw the nut from the bottom (item 6) refer
to Detail 2. Repeat twice.
THANK YOU FOR PURCHASING YOUR INDUSTRIAL WORKBENCH.
Please carefully read and follow these instructions to assemble your workbench.
ENSURE PROTECTIVE EYEWEAR AND GLOVES ARE WORN WHEN ASSEMBLING THIS UNIT.
(1 x ) Wire Bottom Shelf(1 x) Solid Wood Table Top (4 x) Beam
(2 x) Support (2 x) Frame
(4 x) Nuts and Bolts
(4 x) Self Tapping Screw
Check Parts
Safety Instructions
1 3
5
6
7
2
4
4. Should there ever be a need to change the level of the
shelf, be sure to disassemble and reassemble one beam
and level at a time.
5. Use mallet to drive clip of the beam to the bottom of slots
on the end frame. Hit the beam close to the connection.
6. Due to the size of this workbench, 2 people must assemble.
7. If the beam end clip tabs become bent due to mishandling,
it may be necessary to straighten the tabs back into
alignment by using a screw driver.
Step 4: Mount the solid wood table top (item 1) atop the
frame and screw in the self tapping screw (item 7)
with a socket (the holes are not pre-drilled).
Step 5: Place the wire deck (item 2) upon the beam ledge.
Congratulations on assembling your workbench!
TOOLS REQUIRED:
• Rubber Mallet
• 10mm Socket Set
• Phillips Head
Screwdriver
JUN 2022
/
