SUSSEX BTRH Installation guide

BTRH
SUSSEX
Brand
SUSSEX
Model
BTRH
Type
Installation guide
1
2The Brass Wall Fixing must be mounted with
the holes in the Horizontal position as shown.
Horizontal Vertical
Tox Plug
x 2
Brass Wall
Fixing
Fastening
Screw x 2
6.5mm Drilled
Holes x 2
STAINLESS STEEL SET SCREWS x 2
Extension
Product code
Installation guidelines
Suba
- The Toilet Roll Holder is supplied pre-assembled within its packaging.
- Using the supplied 2mm Allen Key, loosen the Stainless Steel Set Screws and remove the Brass Wall Fixing
from the Extension.
- After choosing the fixing location, use the removed Brass Wall Fixing to mark-out the drilling holes.
BTRH Toilet roll holder
Toilet roll holder
Note
- The Brass Wall Fixing must be mounted with the Holes in the Horizontal direction. (see Fig.2 )
- Drill the 6.5mm holes, fit Tox Plugs and secure the Brass Wall Fixing using the Fastening Screws.
- Fit the Toilet Roll Holder over the Brass Wall Fixing, aligned square, and tighten the Stainless Steel Set Screws.
sussextaps.com.au
Tapware is to be installed by a Licensed Plumber in accordance with AS/NZS 3500:2003
Recommended working water pressure 300-500 kpa. Maximum water temperature is 65 deg.c
Copyright © Sussex Taps.
  • Page 1 1

SUSSEX BTRH Installation guide

BTRH
SUSSEX
Brand
SUSSEX
Model
BTRH
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents