Page is loading ...
This manual is intended for users of the DA-MA4100 mounting bracket. It
includes instructions for mounting DA-MA4100 to DA-CM2050 or DA-WM2050.
• This bracket is intended to be used with a specic model of camera.
Do not use it with other models of cameras except for those
approved by the dealer or distributor.
• This installation should be performed by a qualied service
personnel in conformance to all local codes.
• You may need to reinforce the ceiling. If the ceiling is not strong
enough to support the camera, the camera may fall.
• Do not use this product for other purposes.
Mounting
Mount the bracket to the ceiling pipe(DA-CM2050) or wall mounting bracket(DA-WM2050)
as follows:
Screw Set M8X8, 2EA
Ceiling Pipe
(DA-CM2050)
Wall Mounting Bracket
(DA-WM2050)
Cable
Screw Set M8X8, 2EA
1
Insert cables from external devices, network and
power adapter into bracket.
2
Assemble bracket into the ceiling pipe (DA-
CM2050) or wall mounting bracket(DA-WM2050)
and x it by using the screws.
The ceiling pipe
and wall mounting bracket are sold separately.
Connect your camera(DC-D4223RX) to the bracket as follows:
3
Screw the bottom cover onto bracket and then screw the camera dome cover onto the bottom
cover.
Bottom
cover
Bracket
Bottom
Cover
Camera
Dome
Cover
DA-MA4100 INSTALLATION MANUAL
IDIS Co., Ltd.
For more information, please visit www.idisglobal.com
Ver.1.0
4
Turn on power.
Connect your specic model of camera to the bracket as follows:
1
1
3
2
5
4
3
2
5
4
Screw No.1 (2-point): DC-Y6513RX using screw A
Screw No.2 (2-point): DC-Y6513WRX using screw A
Screw No.3 (2-point): DC-D4213WRX, DC-D4513WRX using
screw B
Screw No.4 (2-point): DC-D4223RX, DC-D4233RX, DC-D4533RX
using screw B
Screw. No.5 (2-point): TC-D4222WRX using screw B
<Screw type>
A B
Dimension
Unit: mm (inch)
Ø 40 (1.57)
Ø 34 (1.34)
6.7 (0.26) 6.7 (0.26)
19 (0.74)
67 (2.63)
Ø 144 (5.66)
Ø 94 (3.7)
/
