Page is loading ...
This manual is intended for users of the DA-MA2100 mounting bracket. It
includes instructions for mounting DA-MA2100 to DA-CM2050 or DA-WM2050.
• This bracket is intended to be used with a specic model of camera.
Do not use it with other models of cameras except for those
approved by the dealer or distributor.
• This installation should be performed by a qualied service
personnel in conformance to all local codes.
• You may need to reinforce the ceiling. If the ceiling is not strong
enough to support the camera, the camera may fall.
• Do not use this product for other purposes.
Mounting
Mount the bracket to the ceiling pipe(DA-CM2050) or wall mounting bracket(DA-WM2050)
as follows:
Screw Set M8X8, 2EA
Bracket
Ceiling Pipe
(DA-CM2050)
Wall Mounting Bracket
(DA-WM2050)
Cable
Bracket
1
Insert cables from external devices, network and
power adapter into bracket.
2
Assemble bracket into the ceiling pipe (DA-
CM2050) or wall mounting bracket(DA-WM2050)
and x it by using the screws.
The ceiling pipe
and wall mounting bracket are sold separately.
Connect your camera to the bracket as follows:
3
Screw the bottom cover onto bracket.
Bottom
cover
Bracket
Bottom
cover
Bracket
DA-MA2100 INSTALLATION MANUAL
IDIS Co., Ltd.
For more information, please visit www.idisglobal.com
Ver.1.0
4
Screw the camera dome cover onto the bottom cover.
Bottom
Cover
Camera
Dome
Cover
Bottom
Cover
Camera
Dome
Cover
5
Turn on power.
Dimensions
Unit: mm (inch)
Ø 40 (1.57)
Ø 34 (1.34)
5 (0.2)
6.7 (0.26)
12.3 (0.48)
14 (0.55)
17.2 (0.68)
70.2 (2.76)
Ø 167.2 (6.58)
6 - M4 TAP
DP: 6 (0.24)
51º
6 - 60º
Ø 142 (5.59)
Ø 136 (5.35)
NPT 3/4 inch through
13 (0.51)
151.9 (5.98)
162.1 (6.38)
/
