Legrand Power Pack Installation guide

Brand: Legrand

Model: Power Pack

Type: Installation guide

All information in this drawing is the property of The Watt Stopper Inc. and

cannot be copied or used without the written approval of The Watt Stopper Inc.

≠CAUTION≠

TURN THE POWER OFF AT THE CIRCUIT BREAKER BEFORE

INSTALLING POWER/SLAVE PACKS!

ONLY QUALIFIED ELECTRICIANS SHOULD ATTEMPT TO INSTALL

WATT STOPPER

POWER/SLAVE PACKS!

Installation Instructions

The power pack is attached to existing junction boxes. All low voltage wiring should be

at least 22 gauge wire. All high voltage connections should be at least 14 gauge.

Always check local building codes. After initial wiring is complete, check to verify power

pack is wired correctly. Improper wiring can cause damage to power pack, lighting sys-

tem, and occupancy sensor.

Technical Support:

(800) 879-8585 (972) 578-1699 70-0031-00r2 1/00

Control Output 24VDC

Common

+24VDC

White (Neutral)

Red (Load)

Red (Line)

White

Black

Hot

POWER PACK

SLAVE

PACK

Red (load)Red (line)

OFF switch

Black

Blue

Red

Black

Blue

Switch

Hot

Lighting

Load

Lighting

Load

Any 24VDC Sensor

Ceiling or Wall Mount

Power Pack

High Voltage

connection made

inside J-Box

Two phase

circuit lighting

with two loads

B120, B277, B347

Power Packs

Drawn by: HUCKABONE

PLM:

Project Engr:

MarComm Dir:

Sheet: 1 of 1 Scale: 1 : 1

the Watt Stopper Inc.

SANTA CLARA, CALIFORNIA

Title:

B120, B277, B347 -E/D Power Pack

Installation Instructions

Drawing #: Original Drwg. Date: 22 AUG 97 Rev #:

70-0031-00 Rev. Date: 1 FEB 00 2

MATERIAL: Paper, white, glossy

80# Book

FLAT (cut) SIZE: 120mm W x 160mm H

FOLDING: Quarter fold

INK COLOR: Black

REV. DESCRIPTION INT: REV.DATE APPROVED

1 Release to production 8/22/97 T.Phan

2 ECO# 010700-1

Legrand Power Pack Installation guide

Legrand Power Pack Installation guide

Legrand Power Pack Installation guide

Related papers

Other documents