2. BLOTZ
  3. B28-STA-121

BLOTZ B28-STA-121 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Starship Corridor B28-STA-121. This document provides a step-by-step guide for assembling the 28mm scale model, including attaching supports, panels and embellishments. I'm ready to answer any questions you have about the construction process or the individual parts.
  • What type of glue is required?
    What tools are needed for assembly?
    How to hold pieces while glue dries?
28mm Starship Corridor (Wide to Narrow - Left)
B28-STA-121
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the pieces shown above from the sprue.
Note – the centre support does not have any
lower lugs (see pic).
Glue the supports to the base.
Attach the lower panel.
Glue the centre panel into place.
Add the small triagular piece, then add the top
panel.
The embellishents for this side of the passageway.
Glue these into position as shown above.
Take the pieces shown above from the sprue.
Glue them together as shown.
The corner support is formed from these two
pieces.
Glue them together.
Take these pieces.
Assemble them into a column as shown above.
The embellishments for this side of the corridor.
Glue the wall and column to the base then once
dry) add the embellishments.
The finished section.
/