Shading Systems QDR2 Wall Holder Installation guide

Shading Systems
Brand
Shading Systems
Model
QDR2 Wall Holder
Type
Installation guide

This manual is also suitable for

QdR2 WALL HOLDER
MOUNTING INSTRUCTIONS
Step 1
With a pencil or pen, use the screw holes on the Wall
Holder to mark the desired position on the wall. Installing
on a junction box is neither required or recommended.
Take care to avoid making contact with any wiring behind
the wall.
Use of the Level is recommended to ensure the Wall
Holder is mounted properly aligned.
NOTE: Be sure to install Wall Holder in the correct
orientation, with the QMotion logo facing the
correct direction.
Drill holes where marked and insert the included screw
anchors.
Line up the holes on the Wall Holder with the anchors
and attach with the included screws.
Step 2
If the battery protection tab is
still installed in the QdR2, pull
the tab straight out to remove
it.
Step 3
Insert the QdR2 into the Wall Holder. The QdR2 is
held in the holder by magnetic force. Simply pull the
QdR2 remote away from the wall to release it and
return it back to the wall to store it in the holder plate.
Recommended Tools:
Level
Pencil
Drill with 3/16” sized bit
Flat head screwdriver with 1/4” blade width
Replacing the QdR2 Battery
If battery replacement is needed, remove the rear
housing of the QdR2. Use a U.S. Quarter coin or similar.
Insert the quarter into the slot and twist to separate the
back from the front. Repeat this process around the
QdR2 until the snaps release and the rear housing is
fully separated from the front housing.
Replace the battery with a CR2032 battery. Install the
battery with positive polarity side facing towards the
QdR2 circuit board.
Reattch rear housing by pressing it against front
housing till the snaps click into place.
Pub #9000283r1 Revised: 10/2018
For more information visit us at qmotionshades.com or call 877.849.6070
© 2018 QMotion. QMotion is a trademark. All rights reserved.
  • Page 1 1

Shading Systems QDR2 Wall Holder Installation guide

Shading Systems
Brand
Shading Systems
Model
QDR2 Wall Holder
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents